Quick Question!

Have you ever purchased from PartSelect.com before?

Models > 2370 Maytag > Parts

2370 Hoover Cooktop - Parts

All parts for the Hoover Cooktop 2370

Below is a list of all parts for the Hoover Cooktop 2370. To find the repair part you need, you can browse the list below or you can narrow your choices by searching for a part by name or description.

All Parts for the 2370
1-14 of 77
Search for parts
Keep searches simple, eg. "belt" or "pump". Need help?
$14.17

Grease Filter

This grease filter is almost fourteen inches long and almost twelve inches wide. This filter is intended for use with some downdraft cooktops and ranges.

$83.00

Surface Unit Infinite Switch Kit

This is a push-and-turn switch. This kit includes all necessary hardware to install the part. Switch comes with a D-shaped shaft.

$2.61

Screw

Sold individually. Lock washers are used with screws when vibration from an appliance may cause the screw to loosen. Lock washers are also used in the electrical components of an ...

$23.66

Glass Grease Collecting Jar

This jar is a little over five inches long. It is made of glass and is used for collecting the grease drippings of gas ranges.

$134.36

Grate - Kit of 2

This is the grate that sits over the burner for your pots and pans to rest on while cooking.

$4.30

Drain Jar Lid

This grease jar lid is used for some of Maytag/Jenn-Air's brands of ranges and cooktops. This lid is not quite an inch high and is three inches in diameter.

$72.43

Vent Cover - Black

Black in color.

$17.73

Screw

This screw is sold individually.

$2.76

Locknut

$38.75

Exhaust Vent Blower Wheel

This exhaust vent blower wheel is almost seven inches in diameter, and just under four inches deep. It is made entirely of metal and is used with a range's venting system.

$10.76

Urethan Foam Gasket

$237.21

Blower Motor

This part is used with down-draft models. It helps draw the steam and odors through the vent when the fan switch is activated.

$29.20

Gas Valve/Switch Seal Cover

Part is located on top of the igniter switch that's next to the gas valve. Helps regulate gas flow and the amount of normal leakage that may occur.

Fan Switch Kit

This rocker switch included in this kit is just over an inch long. It is black and is made of plastic as well as metal. Also included in this switch kit is a high heat ceramic wire nut, two spade terminals, and one instructions sheet.

All Parts for the 2370
1-14 of 77