Models > 22RB-4K Maytag

22RB-4K Magic Chef - Overview

Get Parts and Repair Help for 22RB-4K

If you know the repair part you need, you can browse the list of all parts on the 22RB-4K, or you can search by name or part description. You can also find your part by where it is located on the 22RB-4K by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your . Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Sections of the 22RB-4K [Viewing 3 of 3]

$3.81

Rubber Grommet

Used as the bottom feet of a gas stovetop grate. Sold individually.

$3.96

Flashtube Extension

$2.70

Hex Nut

Part may differ in appearance, but functions same as original.

$40.39

Oven Rack

Sold individually.

$48.06

Burner Control Valve with Igniter

$16.93

Igniter Knob

Sold Individually.

$18.76

Top Burner Igniter

Used with RV Ranges.

$3.82

WIRE- IGNI

$99.00

Regulator Kit with Fitting

This part will cut off the flow of gas to your appliance once it reaches a certain pressure.

$30.44

Igniter and Knob

May be different in appearance but will function as the original part.

Common Symptoms of the 22RB-4K [Viewing 1 of 24]

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

The grommets came apart metal from rubber.

  • Customer: Frank from Pierce ID
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required:
  • 11 of 14 people found this instruction helpful
I replaced the broken grommets with the new ones. I purchased 8 so I would have back ups because I did not feel the new one would last either. I think they cost TOO MUCH but I could not haggle for price. read more

range top loose, grommets missing

  • Customer: joseph from wildomar CA
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required:
  • 8 of 11 people found this instruction helpful
very easy to push each grommet into range top holes read more

Factory installed hinges were bent, preventing the oven door to close tightly

  • Customer: Tom from Issaquah WA
  • Difficulty: A Bit Difficult
  • Time to Complete: 1- 2 hours
  • Tools Required: Screw drivers, Wrench(Adjustable)
  • 6 of 11 people found this instruction helpful
Had to turn off the propane, disconnect the propane line and then remove several screws holding the stove in the cabinet. Once I was able to pull the unit out of the cabinet, I had to remove several other screws for the sides in order to gain access to the hinge arm and spring. The front of the oven door had to be removed in order to get to the hinges. Re... read more