Models > 21KPMAWAN7

21KPMAWAN7 Frigidaire Range - Overview

Parts and Repair Help for models starting with 21KPMAWAN7

If you know the range repair part you need, you can browse the list of all parts for models starting with 21KPMAWAN7, or you can search by name or part description. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your range. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Models starting with 21KPMAWAN7

Search for parts
Keep searches simple, eg. "belt" or "pump". Need help?
$48.36

Flat Style Oven Igniter

This flat style gas oven igniter has an amperage range between 3.2 to 3.6.

$35.95

Door Hinge - Left Side

This hinge is located on left side of the oven door.

$34.04

Hinge - Right Side

$39.80

SPARK MODULE

$154.02

Oven Safely Valve

Comes with gas line adaptor and orifice. This part make sure that no gas is released until the igniter gets enough power to ignite the gas range.

$52.37

Rear Top Burner

$137.62

Gas Pressure Regulator

***No Conversion Kit Required - Adjust On Appliance*** This valve automatically cuts off the flow of a liquid or gas when it reaches a certain pressure.

$41.63

ROLLER

$31.64

BUSHING

$7.25

Hex Nut

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

Oven quit heating.

  • Customer: John from Darlington SC
  • Difficulty: Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Nutdriver
  • 373 of 376 people found this instruction helpful
After reading up on the problem of the gas oven not lighting I decided I needed to install a new igniter. I had read where some people just pulled a panel off the back and installed a new one.. yeah, no such luck with this model so I had to crawl into the broiler drawer space [which I had to clean out first]. Note, if you wear trifocal glasses you might as ... read more

Oven was difficult to light, then stopped lighting altogether

  • Customer: Ritchie from Ithaca NY
  • Difficulty: A Bit Difficult
  • Time to Complete: 15 - 30 mins
  • Tools Required: Nutdriver, Pliers, Screw drivers
  • 185 of 260 people found this instruction helpful
1. Turned off circuit breaker to stove
2. Removed the two screws holding down the floor of the oven (screws are at back.), and then lifted it out.
3. Removed the nut holding down the flame guard, and lifted it off.
4. Opened the bottom drawer.
5. Removed the protective cover in the back left of the oven at the bottom, first removing the ... read more

Oven took too long to Light. House smelled like Gas!

  • Customer: JOHN from LA MESA CA
  • Difficulty: Really easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Nutdriver, Pliers, Screw drivers
  • 106 of 172 people found this instruction helpful
Turned Off Breaker!
Removed 2 screws that held Igniter in place.
Cut Old Wires Free
Marked location to old igniter with tape so I didn't cross connect.
Stripped new wire ends.
Used Wire Nuts to connect New part (provided).
Installed New Igniter with 2 screws.
Flipped Breaker On.
Tested
WORKS PERFECT.

Sa... read more