Models > 2055B2A

2055B2A Roper Range - Overview

Get Parts and Repair Help for 2055B2A

If you know the range repair part you need, you can browse the list of all parts on the 2055B2A, or you can search by name or part description. You can also find your part by where it is located on the 2055B2A by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your range. We’ve also included any installation videos we have for 2055B2A parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Search for parts
Keep searches simple, eg. "belt" or "pump". Need help?
$4.87

Blower Wheel Clamp

$41.79

Broil Element - 208V

This broil element is found on the roof of the oven and has push-on terminals.

$2.70

Hex Nut

10-32 hex - Sold Individually - Appliance originally takes 3 of this item.

$42.48

Broil Element

$30.50

SWTCH-LITE

$3.74

SCREW

DISCONTINUED

KEY-3-3010

Cushion-Oven Door (3 Req)

screw 10-32x5/8``

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

Burnt out broiler element

  • Customer: Starla from Vashon WA
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Screw drivers
  • 7 of 7 people found this instruction helpful
Turned off power to range because I was scared. Unscrewed broiler element, pulled part forward and pulled off wires that were attached to the back, attached wires to new element, pushed it back in place, screwed it back on to oven. Cooked my bruchette! read more

BROIL ELEMENT WAS BURNED OUT

  • Customer: DAVID from COTTAGE GROVE WI
  • Difficulty: Really easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Nutdriver
  • 6 of 11 people found this instruction helpful
1. MOVE OVEN OUT FROM WALL
2. REMOVE BACK PANEL OF OVEN, 8 SCREWS
3. REMOVE 3 SCREWS INSIDE OVEN HOLDING ELEMENT
4. PULLED WIRE CONNECTIONS OFF OF ELEMENT
5. REVERSE PROCEDURE TO INSTALL NEW ELEMENT read more

Broiler wouldn't heat

  • Customer: Diane from Mill Valley CA
  • Difficulty: Really easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Screw drivers
  • 2 of 2 people found this instruction helpful
First I removed the ovem door, then I removed the 4 screws, unplugged element and plugged in the new one, then replace the screws and door. It should have been a 10 min job but I'm old and a bit fat...slowed me down. read more