Quick Question!

Have you ever purchased from PartSelect.com before?

Models > 2055B0A

2055B0A Roper Range - Overview

Get Parts and Repair Help for 2055B0A

If you know the range repair part you need, you can browse the list of all parts on the 2055B0A, or you can search by name or part description. You can also find your part by where it is located on the 2055B0A by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your range. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Search for parts
Keep searches simple, eg. "belt" or "pump". Need help?

DISCONTINUED

DISCONTINUED

KEY-3-3010

Cushion-Oven Door (3 Req)

screw 10-32x5/8``

DISCONTINUED

MANUAL, USE & CARE

TYPE 4,BUTANE

Lower Trim

Control Panel Support (Lt. or Rt.)

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

Burnt out broiler element

  • Customer: Starla from Vashon, WA
  • Difficulty: Really Easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Screw drivers
  • 12 of 12 people found this instruction helpful
Turned off power to range because I was scared. Unscrewed broiler element, pulled part forward and pulled off wires that were attached to the back, attached wires to new element, pushed it back in place, screwed it back on to oven. Cooked my bruchette! read more

Broil Element Was Burned Out

  • Customer: DAVID from COTTAGE GROVE, WI
  • Difficulty: Really Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Nutdriver
  • 6 of 11 people found this instruction helpful
1. Move oven out from wall 2. Remove back panel of oven, 8 screws 3. Remove 3 screws inside oven holding element 4. Pulled wire connections off of element 5. Reverse procedure to install new element read more

Broiler unit would not heat

  • Customer: Robert from Atlanta, GA
  • Difficulty: Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Pliers, Screw drivers
  • 3 of 4 people found this instruction helpful
The broiler unit had disintegrated at both connections. I removed the two screws in the top of the oven holder the unit, pulled out the unit, measured and ordered a replacement.

To replace the element, I pulled out the stove, removed the rear panel, located the connections for the broiler unit, remove parts of the old unit. I then attached the... read more