Quick Question!

Have you ever purchased from PartSelect.com before?

Models > 1SF034PEW1

1SF034PEW1 Whirlpool Range - Overview

Get Parts and Repair Help for 1SF034PEW1

If you know the range repair part you need, you can browse the list of all parts on the 1SF034PEW1, or you can search by name or part description. You can also find your part by where it is located on the 1SF034PEW1 by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your range. We’ve also included any installation videos we have for 1SF034PEW1 parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Search for parts
Keep searches simple, eg. "belt" or "pump". Need help?
$2.91

Light Bulb - 40W

Sold individually.

$5.15

Screw, 10-16 x 1

This screw is sold individually.

$5.15

Cover Screw

Sold individually.

$21.68

2 Piece Broiler Pan

The top of this part is now black.

$25.32

Insulation

Oven Wrap Insulation.

$4.89

SCREW

Part might differ in appearance, but functions same as original. Sold individually.

$2.76

Screw

This screw is sold individually.

$21.12

Surface Burner Control Knob

Sold Individually. This knob accepts a D-shaped shaft.

$11.41

BOWL-DRIP

BULK OF 144 PCS.

$41.34

Suface Burner Ignition Switch

When the gas burner valve knob is depressed and turned, this part creates a spark that lights the gas and starts the burner.

Common Symptoms of the 1SF034PEW1

[Viewing 1 of 1]
Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

Ignitor did not spark when turning the know

  • Customer: Richard from Lansing, MI
  • Difficulty: Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Screw drivers
  • 9 of 10 people found this instruction helpful
Had to remove the 4 range knobs, and the oven knob and then the facie. Two screws under the end caps and two on each side from the back on each end. Design defect: one of these screws which attaches through the frame to the facie also attaches the support which holds up the range top. Take that one off last. Remove the two wires that attach to the oven light... read more

Left rear burner would not ignite

  • Customer: John from Perth Amboy, NJ
  • Difficulty: Really Easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Pliers, Screw drivers
  • 5 of 6 people found this instruction helpful
Removed the burner plates. Lifted up the range top. Removed the knobs. Unbolted the 2 rounded nuts at top of face plate. Removed the 4 screws that hold the face plate in place from behind. Un plugged the old switch and plugged in the new one and bam! The burner worked. Thanks, Super fast shipping! The part was here in less than 36 hours. John, N.J. read more

The Oven Would Not Light

  • Customer: RICHARD from GLOVERSVILLE, NY
  • Difficulty: Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Screw drivers
  • 8 of 15 people found this instruction helpful
Removed the defective igniter, removing one screw and disconnected wire, replaced new ignighter in reverse fashion. And WELLA! The old oven works again!! read more