Quick Question!

Have you ever purchased from PartSelect.com before?

Models > 1416^0A

1416^0A Whirlpool Range - Overview

Get Parts and Repair Help for 1416^0A

If you know the range repair part you need, you can browse the list of all parts on the 1416^0A, or you can search by name or part description. You can also find your part by where it is located on the 1416^0A by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your range. We’ve also included any installation videos we have for 1416^0A parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Search for parts
Keep searches simple, eg. "belt" or "pump". Need help?

MODULE-SPK

STIRRER COVER ***

DISCONTINUED

SWTCH-IGNR

IGNTR-OVEN

Switch-Gas Valve

DISCONTINUED

DISCONTINUED

Spacer (2 Req)

SERVICE MOTOR-60 CYCLE (PRODUCTION MOTORS 296086, 295976 OR 295977)

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

the element did not turn compleatly off, the on light stayed on.

  • Customer: chaz from fairplay, CO
  • Difficulty: Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Screw drivers
  • 52 of 58 people found this instruction helpful
removed the screws holding the back metal panel, this exposed the wires to the switch. tested the wires to find that they were live when the switch was in the off position. ordered a new switch. UNPLUGED THE STOVE. removed the knob on the front of the stove. this exposed 2 screws, removed screws and the switch came away from the stove. removed each wire fro... read more

Burner would go high without warning

  • Customer: John from Clinton, CT
  • Difficulty: Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Pliers, Screw drivers
  • 25 of 26 people found this instruction helpful
We felt the only possible problem could be the switch assembly. I removed the switch panel, removed the wires from the old switch, one at a time, removed the old switch assembly and installed the new switch assembly. The extended stem did have to be snapped off (per your instructions) and that too was a very simple task. read more

Left front burner would not adjust heat downward

  • Customer: ALTON from ROUND ROCK, TX
  • Difficulty: Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Screw drivers
  • 26 of 31 people found this instruction helpful
Pull unit away from wall.
Unplug power
remove topmost four screws from rear metal cover
Pull knob off switch shaft.
Remove two screws holding switch to panel.
Break off shaft of new switch to correct length.
Remove each wire from old switch and attach to Corresponding lug on new switch.
Reattach the new switch to the panel... read more