All Installation Instructions for Yard Machines Lawn Tractor 13A2775S000

1 deck belt cover fell off and the other rusted and loosening

Removed the retaining screws on both belt covers and replaced them with the new ones i purchased.

Parts Used:

Cover, Belt, Deck, 42 Powder Black

J. Alonzo from TULALIP, WA
Difficulty Level:
Very Easy
Total Repair Time:
15 - 30 mins
Tools:
Socket set

6 of 7 people found this instruction helpful.

Was this instruction helpful to you?

Thank you for voting!

Oil Drain Sleeve

I wish this was longer...it's only about 6", barely enough to have the oil flow past the metal plate of the riding lawnmower. I'm going to figure out a way to make a permanent extension something like this video would be SO much better https://www.youtube.com/watch?v=G9ZVoeqr6R8&t=79s

Parts Used:

Oil Drain Sleeve

Laurie from RICHLANDS, NC
Difficulty Level:
Very Easy
Total Repair Time:
Less than 15 mins
Tools:
Pliers, Socket set, Wrench (Adjustable), Wrench set

3 of 4 people found this instruction helpful.

Was this instruction helpful to you?

Thank you for voting!

Didn't line up very easy

Put one side in bottom first and you have to slightly twist the lens to get the other clips to pop in.

Parts Used:

Lens-Grill

michael from eden, NC
Difficulty Level:
A Bit Difficult
Total Repair Time:
Less than 15 mins

2 of 3 people found this instruction helpful.

Was this instruction helpful to you?

Thank you for voting!

Mixer began to make a noise on speed two and higher

We took our 30 plus year mixer apart. I removed the old grease. There was some crumbly looking grease in the main housing gear section where the nylon gear is located. It looked like it had flour mixed in it. Not certain. Removed as best possible all old grease and applied 6 oz. of new Benalene grease to all of the gears. Now it does not make the slight howl sound.

Parts Used:

Grease Benalene 920 8 Oz

LISA M from BATESVILLE, AR
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins

5 of 12 people found this instruction helpful.

Was this instruction helpful to you?

Thank you for voting!

Seized bearing and spacer on bolt shaft for idler pulley

Unfortunately I couldn’t find the spacer on the Internet, so I ended up going to the hardware store and buying multiple sizes of spacers and bearings to complete the install. I ended up using a steel spacer with shoulder and two bearings. Way overkill, but worth the three dollars.

Parts Used: