Models > 1393^2A

1393^2A Whirlpool Range - Overview

Get Parts and Repair Help for 1393^2A

If you know the range repair part you need, you can browse the list of all parts on the 1393^2A, or you can search by name or part description. You can also find your part by where it is located on the 1393^2A by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your range. We’ve also included any installation videos we have for 1393^2A parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

$23.61

Burner Switch Kit

This push-to-start Robertshaw style replacement for load rated switches has a clockwise rotation. It also has a break off shaft, and comes with plastic adapters.

$18.07

2 Piece Broiler Pan

$33.48

Heater Wire - 240V

$2.70

Hex Nut

10-32 hex - Sold Individually - Appliance originally takes 3 of this item.

$29.54

Thermostat Knob

$3.82

SCREW

$51.52

SWITCH-INF

STIRRER COVER ***

$3.82

SCREW

DISCONTINUED

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

Dryer wouldn't heat

  • Customer: Edith from Grove City OH
  • Difficulty: Difficult
  • Time to Complete: More than 2 hours
  • Tools Required: Nutdriver, Screw drivers, Wrench(Adjustable)
  • 33 of 40 people found this instruction helpful
Since the heating coil is right behind the front door I had to remove all panels starting with the back one to get to it. The back has a lot of tech screws that I removed with the nut driver. The side panels were removed with a phillips screwdriver. The top is held in place with the other panels. The base was shifted away from the front and I released th... read more

Burner would not heat

  • Customer: Edward from Malvern AR
  • Difficulty: A Bit Difficult
  • Time to Complete: 30 - 60 mins
  • Tools Required: Pliers, Screw drivers
  • 19 of 25 people found this instruction helpful
First i shut off the power since this is an electric cook top/range. I then removed the knob and the two screws that hold the burner switch in place. I removed the wires one at a time and connected each to the new switch. I then reattached the screws to the switch. The most difficult part to me was breaking off the switch stem at the right level. I got ... read more

The switch had shorted

  • Customer: Stephen from COlleyville TX
  • Difficulty: Really easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Nutdriver, Pliers
  • 7 of 10 people found this instruction helpful
I reviewed the schematic. Removed the outer casing. Pulled out the existing wires and replaced them exactly on the new switch. Snipped out off the control stem to match the others. There was a small metal piece on the old stem which holds on the knob. I removed it from the old stem and put it on the new stem and Eureka. read more