Models > 13-3628-23-02

13-3628-23-02 Tappan Cooktop - Overview

Get Parts and Repair Help for 13-3628-23-02

If you know the cooktop repair part you need, you can browse the list of all parts on the 13-3628-23-02, or you can search by name or part description. You can also find your part by where it is located on the 13-3628-23-02 by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your cooktop. We’ve also included any installation videos we have for 13-3628-23-02 parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Sections of the 13-3628-23-02 [Viewing 1 of 1]

$3.51

Drip Bowl - 8"

$5.99

Terminal Block Kit

This surface burner terminal block kit comes with interchangeable mounting brackets, ceramic wire nuts, heat shrink protective tubing and wires.

$22.08

Surface Element - 8" - 2600W

This coil element has looped terminal ends.

$15.25

Surface Element - 6"

This element has looped terminal ends and comes with a black medallion center.

$3.51

Main Terminal Block Kit

$29.30

Burner Switch Kit

$20.46

Surface Control Knob

Sold individually. This knob accepts a double-flat shaft.

$26.04

MEDALLION

$29.18

Indicator Light

$7.64

BUSHING

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

burner shorted out

  • Customer: David from Encinitas CA
  • Difficulty: Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Pliers, Screw drivers
  • 37 of 39 people found this instruction helpful
I followed the directions by clipping wires to old burner socket, splicing the wires to new terminal block, screwing down new "block bracket," and plugging in new burner. read more

Cord was not tightened enough by delivery crew.

  • Customer: Timothy from Spring Valley AL
  • Difficulty: Really easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Screw drivers, Socket set
  • 26 of 48 people found this instruction helpful
PF alarm appeared on display. Noticed clicking when cord was moved. Had arced for some time and melted original block. New part slightly different. Only has 3 lugs, old one had six. Stack using washers provided. Take note of colors before disassembly. Use caution while working through access opening. The edges are sharp. Only tools needed are phillips screw... read more

High heat reluctant to turn down.

  • Customer: George from New Port Richey FL
  • Difficulty: Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Nutdriver, Pliers, Screw drivers
  • 15 of 17 people found this instruction helpful
Most of the job is simple fastener mechanics.
Use a nut driver or Phillips screwdriver. Remove rear panel.

Pull out control knob. If it is stuck, wrap a small rag around the back of it and pull the rag steadily.

Carefully match marked terminals on the replacement switch with those on original. Switch terminals may not be in the sa... read more