Models > 13-2626-00-10

13-2626-00-10 Tappan Cooktop - Overview

Get Parts and Repair Help for 13-2626-00-10

If you know the cooktop repair part you need, you can browse the list of all parts on the 13-2626-00-10, or you can search by name or part description. You can also find your part by where it is located on the 13-2626-00-10 by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your cooktop. We’ve also included any installation videos we have for 13-2626-00-10 parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Sections of the 13-2626-00-10 [Viewing 1 of 1]

$3.51

Drip Bowl - 8"

$5.35

Terminal Block Kit

This surface burner terminal block kit comes with interchangeable mounting brackets, ceramic wire nuts, heat shrink protective tubing and wires.

$4.54

Drip Bowl - 6"

This six inch heavy chrome drip bowl is compatible with electric ranges that utilize plug-in surface burners. This bowl has a narrow 3/8 inch lip.

$17.13

Surface Element - 8" - 220V

4 Turn.

$18.68

Surface Element - 6"

$26.53

Burner Switch Kit

$26.04

MEDALLION

$7.25

Hex Nut

$32.61

KNOB-CONTROL

$5.73

SCREW

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

High heat reluctant to turn down.

  • Customer: George from New Port Richey FL
  • Difficulty: Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Nutdriver, Pliers, Screw drivers
  • 17 of 20 people found this instruction helpful
Most of the job is simple fastener mechanics.
Use a nut driver or Phillips screwdriver. Remove rear panel.

Pull out control knob. If it is stuck, wrap a small rag around the back of it and pull the rag steadily.

Carefully match marked terminals on the replacement switch with those on original. Switch terminals may not be in the sa... read more

Right front burner would over-heat

  • Customer: Melvin from Attica MI
  • Difficulty: Really easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Nutdriver, Screw drivers
  • 13 of 16 people found this instruction helpful
First of all I removed the top panel then removed the switch. I then took pictures of the switch & drew a sketch with all the info. Then I went to your web site, matched up the switch & ordered.
When the switch arrived I went thru the above replacing the bad switch. read more

corroded terminals

  • Customer: Gary from hollywood FL
  • Difficulty: Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required:
  • 12 of 13 people found this instruction helpful
was more of a job of splicing wires together than anything else. Loved the heat shrink electrical tubing
to put over the wires for insulation. used a hair
dryer. must buy more of that amazing stuff read more