This is an authentic replacement part manufactured for use with Craftsman walk-behind lawnmowers. The blade is angled to allow the clippings to rotate through the cutting deck to produce fine clipping...
$32.37
In Stock
Order within the next 3 hrs and your part ships today!
The Side Discharge Chute is a manufacturer certified black plastic part used to direct glass clippings out from unde the deck of the mower, which is rated as "Easy" to install. If broken or damaged, i...
This OEM Hinged Mulch Plug Assembly includes both the plug and the spring. It is a black, plastic assembly which is rated as "Easy" to install, requiring a screwdriver, and socket set. This part seals...
This zone control cable is for lawn mowers.
Zone control cable stops the engine when you let go of the handle.
Wear work gloves to protect your hands during this repair.
$17.50
In Stock
Order within the next 3 hrs and your part ships today!
This trail shield, also referred to as a rear skirt, is designed for use with various makes and models of lawn mowers and is a genuine OEM part. This trail shield is sold as an individual part without...
$10.29
In Stock
Order within the next 3 hrs and your part ships today!
The Blade Support (Bell Blade Support) fits between the bottom of the blade and the blade bolt to provide support for the blade. It is installed underneath the cutting deck on the blade. Installation ...
$5.84
In Stock
Order within the next 3 hrs and your part ships today!
The bag was slightly larger than the original. So the clips along all sides needed to be trimmed slightly to fit the existing frame. 15 minute fix and it works perfect.
I removed the rear wheels, then I removed the blade, then the motor, then the front wheel assembly. The bolts holding the front wheel assembly were rusted and rounded trying to remove them, so I cut them out with a grinder. Afterwards I removed the remainder of the screw with a pair of pliers. I also removed the Water jet cleanout nozz
... Read morele, found it was cracked, ordered the part from PartSelect, along with the screws needed to attach the front wheel assembly. I cleaned the remaining parts and re installed them onto the new deck. First, I installed the front wheel assembly, then the motor, then sat the mower upright, installed the blade, then took the rear wheel assembly and aligned it and fastened it to the deck. Last piece was the water nozzle. I placed it in the recess for it, and fastened it with the bolt. Then I tested the mower, and it worked without issue. Afterwards I used the new clean out port to rinse the underside of the deck, and it worked well.
_WW_1.gif "General Assembly Diagram and Parts List for 2011 MTD Lawn Mower")
_WW_2.gif "Label Map Diagram and Parts List for 2011 MTD Lawn Mower")
