This is an authentic replacement part manufactured for use with Craftsman walk-behind lawnmowers. The blade is angled to allow the clippings to rotate through the cutting deck to produce fine clipping...
This OEM Hinged Mulch Plug Assembly includes both the plug and the spring. It is a black, plastic assembly which is rated as "Easy" to install, requiring a screwdriver, and socket set. This part seals...
This zone control cable is for lawn mowers.
Zone control cable stops the engine when you let go of the handle.
Wear work gloves to protect your hands during this repair.
This trail shield, also referred to as a rear skirt, is designed for use with various makes and models of lawn mowers and is a genuine OEM part. This trail shield is sold as an individual part without...
The Blade Support (Bell Blade Support) fits between the bottom of the blade and the blade bolt to provide support for the blade. It is installed underneath the cutting deck on the blade. Installation ...
Axle assembly attaches the rear wheels to the mower and allows the wheels to rotate.
This part replaces part numbers 911-04144 and 911-04144A.
Wear work gloves to protect your hands when installing this part.
I removed the rear wheels, then I removed the blade, then the motor, then the front wheel assembly. The bolts holding the front wheel assembly were rusted and rounded trying to remove them, so I cut them out with a grinder. Afterwards I removed the remainder of the screw with a pair of pliers. I also removed the Water jet cleanout nozz
... Read morele, found it was cracked, ordered the part from PartSelect, along with the screws needed to attach the front wheel assembly. I cleaned the remaining parts and re installed them onto the new deck. First, I installed the front wheel assembly, then the motor, then sat the mower upright, installed the blade, then took the rear wheel assembly and aligned it and fastened it to the deck. Last piece was the water nozzle. I placed it in the recess for it, and fastened it with the bolt. Then I tested the mower, and it worked without issue. Afterwards I used the new clean out port to rinse the underside of the deck, and it worked well.