Igniter Switch on the burner was constantly on
- Customer: Roman from West Caldwell NJ
- Difficulty: Really easy
- Time to Complete: Less than 15 mins
- Tools Required: Pliers, Screw drivers
- 6 of 12 people found this instruction helpful
To get to the switch I had to remove the knobs and the front panel of the burner valves. There were some dozen screws, top and bottom holding the panel in-place.
The switch slid off the burner valve stem easily but removing the wires I had to pull with the pliers. There seamed not to be a wire release that I could see.
Replacing the wires was no problem. They slid into place by just pushing them in. Assembly was the reverse.