Models
>
117-076-000
117-076-000 (1987) MTD Lawn Mower - Overview
Sections of the 117-076-000
[Viewing 2 of 2]_WW_1.gif "Page A Diagram and Parts List for 1987 MTD Lawn Mower")
_WW_2.gif "Page B Diagram and Parts List for 1987 MTD Lawn Mower")
Keep searches simple, eg. "belt" or "pump".
Lever & Knob Assembly
PartSelect #: PS10034156
Manufacturer #: 94832
The Lever and Knob Assembly (or Front Wheel Height Adjuster) is used to adjust the front height of the mower, and attaches on the front wheels. It can be installed using a socket set and wrench set, a...
$10.36
In Stock
Washer-Lock 5/16
PartSelect #: PS9311087
Manufacturer #: 936-0119
This Washer-Lock 5/16 is a silver, metal part that is sold individually and comes direct from the manufacturer. With a 5/16 Inch Interior Diameter and 1/2 Inch Outside Diameter, it is used to prevent ...
$4.99
In Stock
Throttle Control Wire 55"
PartSelect #: PS9311802
Manufacturer #: 946-0671A
This Throttle Control Wire is a 55-inch black Throttle Cable, made of metal with a rubberized casing. It's rated as "Easy" to install, attaching from the throttle control to the carburetor, and requir...
$14.31
In Stock
Bell-Wash. .40" I.D. x .88" O.D.
PartSelect #: PS10006502
Manufacturer #: 736-0105
This Bell-Wash Flat Washer is an OEM part that measures .40 inches I.D. x 88 inches O.D. This washer is a silver, metal, washer sold individually.
This part is rated as Easy to install by customers....
$4.99
In Stock
Int. Cotter Pin 5/16" Dia.
PartSelect #: PS9164893
Manufacturer #: 914-0104
The Int. Cotter pin 5/16" is an individually sold, silver metal Cotter pin measuring 5/16 x 34. It can be used to secure and lock parts in place, requires pliers to install, and is rated as "Easy" to ...
$3.14
On Order
Questions And Answers for 117-076-000
We're sorry, but our Q&A experts are temporarily unavailable.
Please check back later if you still haven't found the answer you need.
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Rear flap had deteriorated.
Grip each retaining clip next to the housing with large pliers. Squeeze clip completely and pull straight out. Important: Do not attempt to bend clip up or down as clip may bend and become very difficult to remove. When old flap is removed, mower edge can be cleaned and painted to avoid rust. Install new flap in same direction front/rear
... Read more
as removed flap. Reinstall clips in same direction as they were, as up and down sides are not the same.
Read less
Parts Used:
 – Part Number: 731-1029")
-
David from PITTSBURGH, PA
-
Difficulty Level:A Bit Difficult
-
Total Repair Time:30 - 60 mins
-
Tools:Pliers
1 of 2 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!