This part is the replacement gasket for the crankcase on your engine. The gasket helps to create a seal on the crankcase and prevent leaks. If you notice that your engine is not running at peak perfor...
This is a round, inline fuel filter with 0.25-inch nipples, used in a variety of lawn and garden equipment. It is sourced from the original equipment manufacturer and has the capability to filter out ...
This OEM Oil Seal is an individually sold rubber part which is attached around the axis shaft on the crankcase housing to provide a proper seal. A broken seal will lead to a leak, and the part should ...
We're sorry, but our Q&A experts are temporarily unavailable.
Please check back later if you still haven't found the answer you need.
1 question answered by our experts.
Sort by:
< Prev
1
Next >
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Sorry, we couldn't find any existing answers that matched.Try using some different or simpler keywords, or submit your new question by using the "Ask a Question" button above!
Diane
August 14, 2021
What is the intake and exhaust valve clearance for this model? Thanks!
For model number 111P02-0116-F1
Hello Diane, Thank you for writing. The clearances are . 080-inch for the intake and . 100-inch for the exhaust. The exhaust valve expands more due to heat from combustion, and therefore needs additional clearance. We hope this helps.
I have a solid understanding of small engines. This pressure washer was used twice in 2013, when purchased. Sat in a garage for a couple of years with gas in tank and carburetor. Owner was moving and after 7 years of moving it around he sold it at a garage sale. I took it home and took off gas tank and thoroughly cleaned it. Then we
... Read morent through the carburetor and let soak in cleaner. Cleaned up the spark plug, tested and has good spark. reinstalled carburetor but would not start. I knew I had gas issues. I ordered a carburetor kit and replace the needle valve and seals. Still would not start. Ordered a new carburetor and spark plug. Installed both. Two pulls and it runs like new. Advice: don't try to clean out old carburetor, just buy a new one and install.