11082822102 Kenmore Dryer - Instructions

I ordered the Part on Wednesday night, it arrived on Saturday, and was installed by Monday by my husband. This was the best service I have seen in a good while. Kudos to you!

Remove two screws holding front panel of dryer. Heating element is on right side, in a protective tube. Remove the six wires connected to the tube, noting their placement. Remove two screws from front metal bracket holding in the tube. Pull tube out. One screw is holding the heating element in the tube, so remove that and you can replace the element. Then reverse to put it all back together. Clean out all of the lint inside the dryer.

Opened the bottom section removed the heater element replaced it and boom!! It works!!!!!

ordered new latch kit and repaired, very easy thank you

Fantastic site and service !!! Using your site, I i'd my needed part in about 10 minutes. I received my Whirlpool dryer door latch part from you in less than 12 hours. Per your internet site instructions, I replaced the part in a few seconds (just popped it into the slot) and my wife had a working dryer for her Sunday wash. I would have been out $55 and 4 to 7 days waiting for a service call if I had used my home warranty service contractor. Using your service, the part(s) and shipping were just over $12.

Disconnected dryer from power source. Removed bottom panel on dryer. Removed three screws. Disconnected two wires on heating element. Pulled heating element out. Attached new heating element. Success!

I searched the internet and found a paper on troubleshooting for my specific dryer. It suggested the problem maybe the fuse and how to test if the fuse was functioning or not by connecting the wires directly (bypassing the fuse). Sure enough it worked. Then I found this great site and bought the fuse. I received it in only a few days. Made the repair and everything is back to normal.

Took 5 seconds, just snapped in the slot, didn't need any tools.

first turn off the power supply then ..removed the lower front cover. .removed the heat shield that covers the element. .. removed the element and replaced with the new one ..

Did a voltage test found the problem and ordered
the part

I opened up the bottom of the cabinet and found some evidence of burned lint in the heater box. I ohmed out the thermostats and they were good. Then I ohmed out the heater coil and found that it was an open circuit.

Removed the lower front cover of the dryer. Removed the lint filter and removed the cover from the air duct by removing two 1/4" bolts. Removed the two 1/4" bolts retaining the thermistor. Installed the new thermistor and covers.

Snapped latch into existing hole in 2 seconds. The pin that goes into latch was still intact. That's it ,real simple. The only problem I will hopefully not have in the future is the the mico-switch which is just hanging in there, the switch works but the lever that extends out from the face, that works with the door is partially broken off and the switch is no longer available on your parts list. The appliance is twenty-one years old. I am very happy with your service and I received the parts the next day, after I ordered them and I will be buying more parts in the months to come. This time it will be for my Kenmore gas stove and then a Kenmore refrigerator door hinge.

unpluged dryer removed back cover removed heating element replaced new part and back cover job complete

We removed front cover, then removed the part in front of the element. Removed old element after taking out screw that held it in. Then placed new element in.