Quick Question!

Have you ever purchased from PartSelect.com before?

Models > 11070972990

11070972990 Kenmore Dryer - Overview

Get Parts and Repair Help for 11070972990

If you know the dryer repair part you need, you can browse the list of all parts on the 11070972990, or you can search by name or part description. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your dryer. We’ve also included any installation videos we have for 11070972990 parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Search for parts
Keep searches simple, eg. "belt" or "pump". Need help?
$15.40

'M' Series New Style Coil Kit

This gas dryer ignition coil set comes with two ignition coils: one three terminal Boost/Hold coil, and one two terminal secondary coil. Usually only one of them burns out but you ...

$3.71

Door Catch Kit

This kit contains two door strikes, and various door catches to service dryer doors that have one or two catches.

$14.96

Idler Pulley with Tri-Ring and Gasket

A dryer's idler pulley helps the belt to rotate the drum. Also known as dryer belt tension pulley wheel.

$27.79

Lint Filter

This filter collects lint as it passes through the dryer vent.

$18.26

Igniter Kit

This silicone carbide igniter with ceramic holder kit includes the 3" flat igniter, bracket, 5" wire leads, and the plug. Able to replace both round and flat igniters, this kit is ...

$5.15

Leveling Foot

Sold individually.

$40.18

Dryer Drum Seal with Adhesive

This part seals the drum to prevents air from escaping. This includes silicone rubber adhesive.

$7.22

Touch-Up Paint - White

18ml

$184.80

Drive Motor with Threaded Shaft - 120V 60Hz

The blower shaft is 1-5/8 inches long, while the drive shaft is 1-1/4 inches long.

$11.07

Spray Paint - 12 oz. - White

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

Door Catch part had fallen out,/ was missing

  • Customer: Terri from Saint Augustine, FL
  • Difficulty: Really Easy
  • Time to Complete: Less than 15 mins
  • Tools Required:
  • 564 of 579 people found this instruction helpful
Received your parts, Popped them both right into place, Even though only one side needed to be replaced, I wanted them to match up. It was amazing how easy this was. My husband was quite impressed I had ordered these rather then look for either a new or used dryer from some other source. read more

Dryer ran but would not heat

  • Customer: Gary from Haverhill, NH
  • Difficulty: Easy
  • Time to Complete: 30 - 60 mins
  • Tools Required: Nutdriver, Screw drivers, Socket set
  • 277 of 313 people found this instruction helpful
PartSelect showed seven different possibilities why the dryer wouldn't heat. I removed the two screws to remove the bottom panel and turned the dryer on and noticed that the heating element that ignites the gas was working fine. This meant that it was not getting gas so it could be the gas valve or one of the two gas valve coils which are located on top of t... read more

felt strip came off lint screen

  • Customer: JEFFREY from FALL RIVER, MA
  • Difficulty: Really Easy
  • Time to Complete: Less than 15 mins
  • Tools Required:
  • 146 of 182 people found this instruction helpful
ordered new lint screen, removed old screen, inserted new screen. read more