11067082600 Kenmore Dryer - Instructions

Just insert filter.

This was so easy to take apart and put back together following the repair video. I figure my family saved $200.00 by doing it myself.

Exchanged old for new.

i removed the old lens,then removed the bulb,after ordering and receiving your replacement lense,it went back on just like the old one.the repair was very easy. thank you. D.S P.S1 IAM A REPIARMAN NOW!!! WITH YOUR VIRTUAL REPAIRMAN APP,VERY VERY SMART ILL SPREAD THE WORD.

Removed the lower front cover of the dryer. Removed the lint filter and removed the cover from the air duct by removing two 1/4" bolts. Removed the two 1/4" bolts retaining the thermistor. Installed the new thermistor and covers.

No problem changing the element, but it worked for one load and then the thermostat blew! Bummer but that was another easy fix!

Used putty knife to pry broken door catch off .... Snapped in new one. Took maybe two minutes !

I followed the advice and purchased a thermal fuse in advance. The advice forgot to mention a broken belt switch. Since the belt was broken I had no way of knowing how it was wrapped around the tensioner. Their diagrams are reversed from the Whirlpools. I called a local parts supplier, who turned out to be a repairman working out of his van. I met him in a restaurant parking lot and was on my way in minutes. The dryer was running within a hour. Great web site George - Pittsburgh

Well the Youtube video was helpful. BUT that only worked on a catch that WASN't broke. I had to bend it up and push it into the door. New one went in easy

I used a screw drivers and put the old one out, and put the new one in. It was very easy for me to do.

After shutting off the gas supply and unplugging the electrical cord, I used a flat blade screwdriver to loosen the exhaust vent clamp and remove the vent tube from the outlet. Using a 1/4-inch nut driver I removed the screw holding the plate covering the electrical lead connection to the power supply, then I pulled the plate back and disengaged the tab from the cutout in the back of the dryer body to remove it. I then removed the eight screws holding the back cover of the dryer in place, then removed the cover. The thermal fuse is located near the bottom of the dryer at the back, just above the exhaust vent. I loosened the two screws holding it in place using the 1/4-inch nut driver, then I removed the two electrical leads from the fuse. I inserted the new thermal fuse and screwed it into place, then reinstalled the electrical leads. I then reinstalled the back cover, the power-cord cover, and the vent hose. I turned the gas supply back on and plugged the electrical cord back in.

replacement - pry out the old, snap-in the new

replaced the lent filter

diognostic suggested thermal fuse or thermistor. Thermistor tested low resistance (<2K olms). Replaced thermistor and dryer heat returned.

Took the old one out and replaced with new filter.