Quick Question!

Have you ever purchased from PartSelect.com before?

Models > 11062904100

11062904100 Kenmore Dryer - Overview

Get Parts and Repair Help for 11062904100

If you know the dryer repair part you need, you can browse the list of all parts on the 11062904100, or you can search by name or part description. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your dryer. We’ve also included any installation videos we have for 11062904100 parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Search for parts
Keep searches simple, eg. "belt" or "pump". Need help?
$3.71

Door Catch Kit

This kit contains two door strikes, and various door catches to service dryer doors that have one or two catches.

$14.96

Idler Pulley with Tri-Ring and Gasket

A dryer's idler pulley helps the belt to rotate the drum. Also known as dryer belt tension pulley wheel.

$27.79

Lint Filter

This filter collects lint as it passes through the dryer vent.

$24.29

Thermal Cut-Off Kit

This kit includes one high limit thermostat with a limit of 250 degrees Fahrenheit, and one thermal cut-off fuse with a limit of 360 degrees Fahrenheit. The thermostat and fuse help prevent the dryer from overheating.

$6.42

Heating Element Connection Wire Kit

This kit is used for electric clothes dryers, and it comes with a yellow wire nut.

$5.15

Leveling Foot

Sold individually.

$40.18

Dryer Drum Seal with Adhesive

This part seals the drum to prevents air from escaping. This includes silicone rubber adhesive.

$7.22

Touch-Up Paint - White

18ml

$184.80

Drive Motor with Threaded Shaft - 120V 60Hz

The blower shaft is 1-5/8 inches long, while the drive shaft is 1-1/4 inches long.

$34.56

Terminal and Wire Kit

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

Dryer blew cold air.

  • Customer: Tom from High Point, NC
  • Difficulty: Easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Nutdriver
  • 579 of 610 people found this instruction helpful
PartSelect is great for providing parts as requested. Unfortunately, neither of the 2 parts I ordered were on my machine. My bad for not looking at the actual part instead of the description. A word to the wise! read more

Door Catch part had fallen out,/ was missing

  • Customer: Terri from Saint Augustine, FL
  • Difficulty: Really Easy
  • Time to Complete: Less than 15 mins
  • Tools Required:
  • 563 of 578 people found this instruction helpful
Received your parts, Popped them both right into place, Even though only one side needed to be replaced, I wanted them to match up. It was amazing how easy this was. My husband was quite impressed I had ordered these rather then look for either a new or used dryer from some other source. read more

Burned out heater element

  • Customer: Alan from Brooksville, FL
  • Difficulty: Easy
  • Time to Complete: 30 - 60 mins
  • Tools Required: Socket set
  • 341 of 378 people found this instruction helpful
Remove the kick plate from the bottom of the dryer by sliding a putty knife along the top edge to release the plastic clamps, one on each side about 4" in from the edges. The kick plate folds out and down. You will see the heat shield on the right, held in by one hex head screw. Remove screw and heat shield. The element is positioned in an open-front housing... read more