Quick Question!

Have you ever purchased from PartSelect.com before?

Models > 11061086000 > Parts

11061086000 Kenmore Dryer - Parts

All parts for the Kenmore Dryer 11061086000

Below is a list of all parts for the Kenmore Dryer 11061086000. To find the repair part you need, you can browse the list below or you can narrow your choices by searching for a part by name or description.

All Parts for the 11061086000
15-28 of 130
Search for parts
Keep searches simple, eg. "belt" or "pump". Need help?
$7.83

Dryer Door Switch Actuator Spring/Lever

This black actuator spring with white rubber tip is used for both dryer doors and washer lids.

$32.12

Dryer Drum Seal with Adhesive

This drum seal with a silicone rubber adhesive is used in dryers. This part seals the drum to make sure air does not escape from the dryer. If your dryer is making loud noises, is not producing enough heat, or no heat at all, or there are marks left on your clothes, replacing the seal on your dryer can solve the problem. The tools needed for this installation project are: 1/4 inch nut driver, Phillips screwdriver, small flat blade screwdriver, and putty knife. Remember to unplug your dryer from the power source before beginning this installation project. Refer to the manual provided by the manufacturer for installation instructions.

$19.19

Lid Switch

This 3 prong lid switch is used for washing machines that do not have a tub light.

$3.02

Cover Screw

Sold individually.

$6.18

Screw, 10-16 x 1

This screw is sold individually.

$37.64

Wheel, Blower

The blower wheel pulls air over the heat source, through the clothes drum, and past the thermostats, then pushes it out the exhaust duct. The blower wheel, which is usually plastic, may wear out over time. But if it's noisy, it may simply be clogged with lint. Clean the blower and test to see if the dryer is still noisy. If it is, you probably need to replace it.

$27.03

Drum Support Shaft - Left Hand Threads

This shaft is for the front with left hand thread. Sold individually.

$3.02

Screw with Washer

This metallic screw is less than an inch long and comes with a plastic washer.

$34.95

Motor Pulley

$53.23

High Limit Thermostat - L295-50F

This hi-limit thermostat acts as as safety mechanism that keeps the dryer from overheating. Once the dryer temperature reaches a certain point, this piece will shut down power to the heating element.

$4.63

Single Access Panel Spring Retainer/Clip

Sold Individually.

$4.79

Washer, Support

This part is located on the drum roller support shaft in your dryer appliance. The exterior of the washer is 1 inch in diameter with a hole in the middle and is made of metal. They are installed alongside the drum support rollers and idler pulleys. If you notice that your dryer is making an unusual sound it could be due to the washer becoming loose on the drum support. They help prevent the rollers and pulleys from bumping up against the brackets they are installed on. If you are replacing the rollers, we suggest you replace the washers at the same time.

$3.02

Leveling Leg Locking Nut

This nut is sold individually. Size: 3/8-16

$161.15

Drive Motor with Threaded Shaft - 120V 60Hz

The blower shaft is 1-5/8 inches long, while the drive shaft is 1-1/4 inches long.

All Parts for the 11061086000
15-28 of 130