11060854990 Kenmore Dryer - Instructions

Remove two screws on top holding the filter frame.Use flat screwdriver to snap top at front off front panel.Swing top up and secure it against wall or tie in place. Remove screws holding front panel and kick panel to side panels.Did'nt remove back panel.Remove drive belt from pully wheel and then use belt to lift out drum.Use open end wrench on motor pully at rear and I used a socket set on the front of motor,Push down on wrench,counter clockwise,and hold the front pully from moving mine came right off. My dryer is over 10 yrs so the electric conection was changed but the instruction sheet explained how to change the wires,just follow the wire color,easy.

I found some help on-line that suggested some of the most likely causes. The on-line videos showed how to remove clips/panels to access the parts. Once I found the possibly failed parts, door switch and thermal fuse, I did a quick continuity check and found that the thermal fuse had an open circuit.

Took off the backplate of dryer, replaced fuse, done.

Simply changed the designated parts according to instructions.

unplugged unit, removed the back panel replace thermo fuse and replace back panel, plugged electric cord back in and we were back in business. real easy fixx

quite simply I followed the path that was worn from years of use. it was very apparent the belt had broke. along with the belt there was a generic diagram for proper install. this was very helpful

After testing all the thermostats, I realized it was the heating element. I ordered the part right away, it came in 2 days later. It took me 15 minutes to open the dryer, put the new part in and then close the dryer. I must have saved $200. Thanks partselect for the videos and the fast shipping.

I followed the video on the website, removing the back of the dryer, then located and removed the thermal fuse, replaced it with the new one..... Presto, it worked... Replaced the back of the dryer and was good to go... Thank you Part Select

replaced thermo fuse. not the problem. not sure how to test for next step. timer, cycler tumbler all work just won't fire up.

Opened dryer top, disconnected door wireing, took off front panel, laid dryer on back, cleaned out lint and inside, put new belt on, and put parts back together. Dryer works fine now.

Remove Filter and (2) phillip screws. Use common screw driver to pry top from cabinet. Fold top back. disconnect door switch and removed (2) screws holding front of cabinet and lift frong slightly to remove from cabinet. Remove broken belt and discard. check rollers for freedom and placed drum on rollers. guided belt through idler and around motor pulley. lift front and placed on lower hooks. Lift drum and installed (2) screws that holds front of cabinet to main cabinet. connect door switch and check drum for freedom of turn. turn drum several times to get belt to center. Closed top and replaced (2) screws that hold filter door in place. Install filter and test run dryer. Completed job in about 38 minutes.

I followed the instructions supplied with the belt. I've changed the belt before so was familiar with the repair. The toe panel clips for my model had changed so what was supplied was different than the originals. Although they, too, came with instructions, they did not fit my appliance. They were inexpensive so I scrapped them and used some self-adhesive Velcro fasteners I had in a junk box.

I followed the instructions from the video and had no problems

belt # 346995. part was delivered quickly. Part fit perfect, no problem. there was a video on youtube how to replace it. It took about 25 minutes from start to finish to install. works like a new one. Thanks partselect.

I watched your YouTube video about trouble shooting dryers, and found that the problem was my thermal fuse was out. My exact model of dryer was used in the video. I ordered the part and replaced it following the instructions on YouTube. Since the video was so helpful, I decided to order my part from your company