11060712990 Kenmore Dryer - Instructions

Took old bearing off replaced with new

Watched a you tube video on replacing a dryer belt for a whirlpool dryer. Perfect instructions. Dryer is working great.Thank you

video on your website made it super easy

This is a straightforward repair that you can do in an hour or less. Open the lint trap and remove the two screws. Use a screwdriver to pop up the top of the dryer. Remove two screws that attach the front panel. Now you can lift out the drum and then lift off the front panel. Clean out all the lint. Make sure the motor pulley turns smoothly. Tilt back the dryer diagonally to make the rest go easier. Loop the new belt around the drum (rubber side down) and reinstall the drum against the back wall of the dryer. Make sure the cloth liner fits perfectly around the ridge, with no folds so the drum rotates easily. Make sure the drum fits smoothly against the two rubber positioning wheels on the back wall. Position the new belt around the center of the drum. On the dryer floor, stand up the tensioner bracket. Tricky part -- thread the belt so it runs through the bracket and loops around the drive pulley on the motor, rubber side against the pulley. The belt should be tight, held by the tensioner. Reinstall the front panel so the opening aligns with the drum opening. Drop the top down, snap into place.and reattach the screws in the lint trap. Done!

watched the video on part select.com was a very easy job whenever you had someone showing you what needed to be done,thanks for the help and great customer service.

Just follow the video by Parts Select., The repair is really easy.

Disconnect back of dryer gas/elec then I unscrewed the back panel, and chisel the panel off with a hammer and a old wood chisel to remove the welds spots, changed out the thermostat and I had to use tap screws to put back panel

used your video instructions were great a great tool to repair. know wonder the maytag man is not busy ha ha .

Power off by removing plug from wall outlet. Remove two Phillips screws under lint screen filter door. (careful you don't drop them down the filter housing) Pry upper lid loose at both front corners and elevate and retain the lid vertically. Separate old 3 wire switch connector splice halves at upper right housing corner. Remove two Phillips screws at upper right corner of outer front doorway which hold switch. Install new switch with those two screws. Re-connect the connector splice halves; they are keyed for one direction. Close down lid. Plug in power cord.

i replaced both the high limit and cycling thermostats because cost was not that much and these thermostats change settings as they age. After replacing the thermostats the problem was solved.

watched the repair video and had no problem doing the repairs. they were VERY helpful!

Per video demonstration offered in web. Very simple. Thanks for your help.

so being the WOMAN that I am I decided to take it apart. well low and behold I found out it was the pulley and belt so I decide too order from parts select easiest thing I've ever done yay me

Video showed 3 ways to remove the top section to access the switch. None of which worked on my unit. Instead there were 4 screws on the rear section of the control panel that had to be removed and then lift it past the top of unit to slide forward to remove top to access the switch after that all was the same as video.

I googled the main reasons why a dryer wont start. Ordered the suggested parts and went through them one by one. Replaced thermal fuse as it was said this was a main reason it wont turn on. Kept the new fuse in as I believe it was the original. Then I went to the door switch when I compared them I knew I had found the cause. I replace the door switch then plugged it back in and success. I took it a step a time. .