Models > 11027032602

11027032602 Kenmore Washer - Overview

Get Parts and Repair Help for 11027032602

If you know the washer repair part you need, you can browse the list of all parts on the 11027032602, or you can search by name or part description. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your washer. We’ve also included any installation videos we have for 11027032602 parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Search for parts
Keep searches simple, eg. "belt" or "pump". Need help?
$2.88

Inner Cap Seal

Also known as an O-Ring.

$3.96

Agitator Cap Barrier with Seal

$111.50

Drain Pump

This pump helps expel water from the washing machine and is activated after the spin speed is maintained for a specific period of time.

$2.70

Hose Clamp

$25.05

Basket Hub Kit

$60.88

Suspension Rod Kit

This part helps center and support the drum, transmission and motor assembly. There are 4 rods in this kit.

$71.82

Lid Lock Assembly

Also known as Latch. As per the factory, this part uses the magnet to latch and the magnet is only available with the inner lid.

$2.03

Lid Hinge Mounting Screw

Sold individually.

$2.70

Hose Clamp

This hose clamp is sold individually.

$2.03

Screw with Washer

This metallic screw is less than an inch long and comes with a plastic washer.

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

Loose change entered drain pump, cracked housing leaked all water out

  • Customer: ROBERT from BARRINGTON IL
  • Difficulty: Easy
  • Time to Complete: 30 - 60 mins
  • Tools Required: Nutdriver, Socket set
  • 93 of 102 people found this instruction helpful
Disconnect power, hot/cold supply and drain hose. Tip washer onto front side, expect some additional water to leak out. Remove the cracked drain pump, 3 screws, hose clamps, and electrical plug.

Tip washer back up, use the putty knife to pop the top cover up (clips are about 6.5in in from sides). Unclip the white plastic cover over the outer and i... read more

Washer always stopped at the 47th and 24th minute of each load and display F1 error code. I would have to press "cancel" and then "start" a few times for it to continue.

  • Customer: James from Turnersville NJ
  • Difficulty: Really easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Pliers, Screw drivers
  • 78 of 90 people found this instruction helpful
Removed the dial control top covering by unscrewing the 3 screws in the back of the cover. Once the cover was off, the control module was exposed and all I had to do was:

1. Disconnect the wires that were plugged into the control module

2. Remove the old module. There was 1 screw holding it in place.

3. Replace with the new... read more

Within 10 minutes of starting the washer, it would stop. Grreen flashing lights and F1 error code appeared.

  • Customer: Arthur from Linden NJ
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Screw drivers
  • 27 of 30 people found this instruction helpful
Someone on Google suggested holding the stop button and the start button at the same time for 60 seconds as a way of by passing the problem. This did work but soon became a pain each time we used the washer.Installing the new part was super easy. Three screws hold the cover on, one screw holds the part in place and all the plug- ins are marked by color as to... read more