Quick Question!

Have you ever purchased from PartSelect.com before?

Models > 11027032600

11027032600 Kenmore Washer - Overview

Get Parts and Repair Help for 11027032600

If you know the washer repair part you need, you can browse the list of all parts on the 11027032600, or you can search by name or part description. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your washer. We’ve also included any installation videos we have for 11027032600 parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Search for parts
Keep searches simple, eg. "belt" or "pump". Need help?

Drain Pump

This pump helps expel water from the washing machine and is activated after the spin speed is maintained for a specific period of time.


Seal, Inner Cap

Also known as an O-Ring. This black o-ring seal is three inches in diameter.


Basket Hub Kit


Agitator Cap Barrier with Seal


Hose Clamp


Lid Lock Assembly

This part makes sure that the lid is shut before allowing the machine to start or agitate. NOTE: This is a manufacturer substitution. Part may differ in appearance but is a functional equivalent to prior parts including


Screw with Washer

This metallic screw is less than an inch long and comes with a plastic washer.


Touch-Up Paint - White



Hose Clamp

This hose clamp is sold individually.


Lid Hinge Mounting Screw

Sold individually.

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

Loose change entered drain pump, cracked housing leaked all water out

  • Customer: ROBERT from BARRINGTON, IL
  • Difficulty: Easy
  • Time to Complete: 30 - 60 mins
  • Tools Required: Nutdriver, Socket set
  • 172 of 197 people found this instruction helpful
Disconnect power, hot/cold supply and drain hose. Tip washer onto front side, expect some additional water to leak out. Remove the cracked drain pump, 3 screws, hose clamps, and electrical plug.

Tip washer back up, use the putty knife to pop the top cover up (clips are about 6.5in in from sides). Unclip the white plastic cover over the outer and i... read more

Washer always stopped at the 47th and 24th minute of each load and display F1 error code. I would have to press "cancel" and then "start" a few times for it to continue.

  • Customer: James from Turnersville, NJ
  • Difficulty: Really Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Pliers, Screw drivers
  • 136 of 155 people found this instruction helpful
Removed the dial control top covering by unscrewing the 3 screws in the back of the cover. Once the cover was off, the control module was exposed and all I had to do was:

1. Disconnect the wires that were plugged into the control module

2. Remove the old module. There was 1 screw holding it in place.

3. Replace with the new... read more

Water pump for draining

  • Customer: Kerry from Alleyton, tX, TX
  • Difficulty: Easy
  • Time to Complete: 30 - 60 mins
  • Tools Required: Nutdriver, Pliers, Socket set
  • 55 of 65 people found this instruction helpful
The actual install of the pump was extremely easy. I removed the back cover, (After unhooking water, drain and electricity. I laid the machine on its front ( USE CAUTION WHEN DOING THIS, THERE ARE SHARP EDGES on the FRAME) After bandaging my cut fingers, I used a nut-driver/screwdriver to remove the screws, pliers to remove the Spring clamps, unhooked the wi... read more