11026842691 Kenmore Washer - Instructions

had to take the entire shell off the washer and then it was 2 simple clamps.

I watched the video on your site of the fellow demonstrating the repair and was able to do it myself. The video was right on the money and the repair was exactly as the video showed. I spent maybe an hour and a half. It would have been much less but I'm not that mechanically inclined. I figure to have saved at least a couple of hundred dollars. Thanks. Will definately use you again.

Prior to this repair I have never performed repair work on a washing machine. The video that was provided online was accurate and easy to follow which took all the mystery and headaches out of performing the repair. If the videos supplied by Parts Select with appliance parts make future repairs this easy I will never call a service man again.

Watched the video on this sight. Fallowed instructions in video and everything went very smooth.

Unplugged, removed water supply hoses, removed drain hose from washer, laid whole washer on it`s back without removing the cabinet, popped clips off the water pump and laid to side, took two screws out of clips that hold motor on and popped them off with a screw driver, unplugged wiring harness and another single wire on motor and then lifted motor off. Then pried the plastic pieces of the coupling off the the motor and transmission shaft. Cleaned debris off motor and washer, replaced plastic piece to the transmission and set rubber part on plastic. Then replaced new plastic piece on motor and set motor back into bracket and put all parts back on in reverse order. I make it sound hard but was a easy job.

disconnected the power, the water supply hoses and took the drain hose out of the wall. Tilted the washer back, undid the 2 clip,took the pliers slid the clamps back. Installed new pump. Put everything back. Done.

Our washing machine "squealed" as it filled. Only the hot water did it, the cold water did not. The hot water came in real slowly, and the machine made a squealing noice and the hose going into the fill valve would vibrate. When I ordered the part, on my order confirmation email there was a link to a video showing how to replace the fill valve. It literally took my less than 30 minutes to replace the part. The only thing that was different on my machine was the screws holding the controls on. Mine were hidden under a plastic cover on the front that I had to snap off. Other than that slight difference in screw location, everything in the video matched up perfect with my machine. With the new fill valve the machine fills in 1/2 the time. We hadn't really noticed how slow it was filling until the squealing noise started. After changing the valve, the difference in fill rate was very apparent. I'm sure the 15 year old valve was full of sediment and minerals. Works like new now.

I followed the video on replacing the direct drive coupling. It was easy to follow and gave step by step instructions for screw locations, fastener and part removal and installation.

Followed your online repair which I found very helpful and easy.

The spin cycle was super slow leaving clothes soaking wet at the end of a full wash cycle. Ordered a clutch repair kit, watched the how to video that was e-mailed to me with my order while I did the repair and got it done in about 45 minutes. This was my first true appliance repair outside of maybe a busted fuse or replacing the heating element in a stove. Never thought taking the motor, transmission and clutch out of the washer and putting all back together would be so very simple. Meanwhile my wife is pissed because she thought she might be able to go get a brand spankin new washer...until I fixed the old one. Thanks for saving me some dough PartSelect.

So we had two washers both with faulty lid switch assemblies. We watched your video and were able to change out the parts in one morning. Much shorter time than we estimated. Thanks for the right parts and the video.

Half inch ratchet extension unscrew remove replace cogs reinstall retainer ring drop back in . Watch how fast agitator spins.

I viewed the repair video provided and then dove into the project. I am sorry to say that the time suggested for the fix was a bit misleading. Took me less than five minutes rather than the fifteen minutes suggested. Thanks Parts Select for a great assistance in saving me an expensive repair call!

Disconnect water supply hoses, water drain hose, power cord. Move washer into position to lay on it's side. Use pliers to remove hoses on direct drive. Pull direct drive away from electric motor, replace with new direct drive. reconnect washer in it's place. done.

took broken agitator dogs out and put new parts in, it was very easy repair.