Have you ever purchased from PartSelect.com before?
Thank you for helping make our site better.
Below is a list of all parts for the Kenmore Washer 11025862400. To find the repair part you need, you can browse the list below or you can narrow your choices by searching for a part by name or description.
This hose clamp is used in a wide variety of household appliances. Most often it is found in washers, dishwashers, refrigerators, freezers, dehumidifiers, garbage disposals, or air...
This water inlet valve attaches the water lines to the back of your appliance. The attaching solenoids on the valve open and close according to the desired temperature, or amount of water needed.
This kit comes with the clamps.
This hose goes from valve to inlet.
This part is for large capacity belt drive and direct drive appliances.
This hose can handle hot or cold water and is five feet long.
The hose clamp is used to hold the water hose in place which will prevent the hose from leaking water. Sometimes the clamp may lose its ability to latch on, causing a leaking washer. For the installation, you will need a flat head screw driver to replace the clamp and a drill to access the screws to remove the front of the washer. Be careful if you do not have specific clamp pliers as the clamp could fly off. Once the front of the washer has been removed, take a quick look for water damage or any obvious signs of where the leak is coming from. If it is not obvious, run water to test.
This part goes on the agitator retaining bolt.
This part holds the bleach until it is ready to be released into the cycle.
This gray and white washer lid bumper contains a rubber bottom and is sold individually.
This is used in your direct drive washer that has a neutral drain.
All brand logos are trademarks of their respective owners.
The PartSelect logo is a Registered Trademark of Atlantic Laundry Centres, Ltd.
Copyright © 1999-2017 , Eldis Group Partnership. All rights reserved.