11022982101 Kenmore Washer - Instructions

This was an easy repair. I used a 7/16th socket on a 8 inch extension to reach the agitator bolt. After removing the bolt, I pulled off the top half of the agitator, leaving the bottom half intact and attached to the washer. After that it was a simple replacement of the agitator directional clutch dogs and then putting the top half of the agitator back in place and tightening the bolt.

thanks for the part, it worked!

Pretty much as directed. My only issue was the rust on the old part. It made it difficult to remove the old and to put on the new one. At first the new one wouldn't fit since the rust had essentially changed the size of the metal rod the new pump had to fit on. So I had to spend time sanding down/off the rust. But in the end I was able to do it and the part works great!

Watched the video and it was very straight forward, very easy and time saving. I just wish the delivery time for the part was that fast (It was a quick delivery).

Seal on the lid split. New seal easily replaced. It just snapped into place.

Disconnected water and power supply. Turned washer face up and removed pump. Easy to install just 2 hold down clips.

Removed washer cabinet. Unclipped pump and disconnected hoses. Put hoses on new pump. Attached pump to drive unit and reinstalled cabinet.

It was a no-brainer repair. We removed the worn hose and replaced it with the new one. Only variable was that the new clamp was too big for our fitting, so we used the old one. The clamp was the only mechanical thing we did. The best part was the very prompt delivery of the new part and the help finding it from the rep at the company.

repair went well. video presentation was helpful but our washer was not quite the same as video. we had to print the assembly diagram to visualize the proper order to place the new parts. all in all it was a simple fix.

Pop cap off top of agitator. remove bolt that holds down agitator,which lets you remove the top of agitator that holds the directional cogs. remove top install cogs, make sure they are turned in right direction, and re install top of agitator.

your instructions in the video were excellent, but the shaft of the motor was too corroded to reuse.

as in video

it went very fast after watching the how to fix video

After about 4-5 years, the agitator cogs or "dogs" will wear out and cause the agitator to stop working-Simply pop the cap off of the top of the agitator with your hands by pulling upwards, remove the plastic cap at the bottom of the agitator-there are 2 plastic ears that you pull up on also with your hand, exposing a 1/2 locking nut. Use a socket and extention to unscrew the nut. Grab the bottom of the agitator with both hands and pull sharply upwards removing the entire assembly. Flip the assembly over to expose the four cogs. Replace with new, and reverse the procedure to reinstall the agitator

Determined based on some Internet searches that the part that we needed was the motor coupling; washer would not spin or agitate. Once I figured out how to removed the cover (by the way, one of the guys at an appliance store told me how to do it), and reviewing the video on your website, I removed the two screws and four clips, dropped the motor, inserted the parts and put it back together - all in about 15 or 20 minutes. It was easy and clean and the washer worked again. Hopefully go for another 5-10 years. Thanks.