11021102012 Kenmore Washer - Instructions

with socket and rachet with adapter took me like one min. to take off part about one min. to take it apart to get to cogs. and about two mins. to put back together. i say it took 15 to 30 mins. because while parts were off and apart i cleaned them all before putting back together. can't beleive such little parts caused so much trouble. machine runs like new now. thank you

pulled lid off[fabric softner already removed], removed 7/16 bolt, pulled up, removed dogs, replaced with new, reassembled,and WIFE HAPPY!!!

Found a video showing repair steps on YouTube. Removed agitator cap, seal and retaining nut. Replaced old cogs and reassembled.

Pull top cap off, removed inner disk, used 7/16 socket to remove bolt and replaced cogs. Thanks for instructions online. Ken

Just follow the partselect video connected to the part! I have tracked down some appliance parts locally in the past but I must say that using partselect was so much easier and educational than driving across town and/or making calls. For $10, the 10yr old washer is back and operational as it should be. It's only about a 15 minute job but after reading other comments here, I went ahead and cleaned the scum(yes you have it too) on the inside of both the bottom and top agitator pieces. If I need appliance parts, I will be back to partselect. Ordered Sun at 930p and got part Tue at 10a. Great Job! Great Service! Good to see it still exists out there.

I could not separate the upper part from the lower part of the agitator as easily as it was shown on the video. Then I realized I would have to physically cut the horizontal tab of the upper agitator from the vertical tab of the lower agitator (they were manufactured as one part), and leave the vertical tab intact. Once I did that, I was able to remove the upper assembly and replace the worn out parts. I then installed the repair kit in the existing upper agitator, aligned the slots of the repair kit with the existing lower agitator vertical tabs and tightened the bolt. The machine is 22 years old! Works great!

watched video on facebook, and followed the instructions,one of the easies repairs I have had to do in a long time.

removed the aggitater and the replaced coggs, no difficulties at all ,thanx for the very quick parts delivery

I watched your'e easy to do repair video and it was so easy. I just followed the instructions and it saved me an expensive service call as we live in a rural area. Thank you so much.

very simple fix. if your machine works great, but doesnt agitate, replace those dogs. works like new, for about 10 bucks

Well pop off the plastic cap, remove the nut that holds the agitator on and lify off the unit. Replace the cogs and return the machine to service. I was afraid to even look at this, what an easy repair. The parts were ordered and they arrived at my house the next day, no special delivery or extra postage paid, just prompt service from these folks, they ROCK!

I watched the video on the page with the parts I ordered. The machines were not the same, but the principle was the same. Did as instructed, except for being creative with the tools on hand. It all made sense by the time I got it apart.

Followed Video link to instructions and finished job in 10 minutes. Really easy repair.

1) Using a Phillips head screwdriver, the two screws retaining the hinge pin to the lid were removed. 2) Remove hinge pin and tilt lid slightly to gain access to bushing hole. 3)Install new bushing in hole. 4)Reposition lid. Insert hinge pin through lid and into bushing. 5)Reinstall hinge pin retaining screws and tighten.

The fix was super easy. The parts were less then the shipping and had my parts one day ahead of the estimated time on the internet. It was a Bing Bang Boom project that saved the fiance and me a few bucks.