Quick Question!

Have you ever purchased from PartSelect.com before?

Models > 11016852503 > Parts

11016852503 Kenmore Washer - Parts

All parts for the Kenmore Washer 11016852503

Below is a list of all parts for the Kenmore Washer 11016852503. To find the repair part you need, you can browse the list below or you can narrow your choices by searching for a part by name or description.

All Parts for the 11016852503
15-28 of 184
Search for parts
Keep searches simple, eg. "belt" or "pump". Need help?
$3.02

Hose Clamp

This hose clamp is used in a wide variety of household appliances. Most often it is found in washers, dishwashers, refrigerators, freezers, dehumidifiers, garbage disposals, or air...

$58.14

Water Inlet Valve and Thermistor Assembly

This water inlet valve attaches the water lines to the back of your appliance. The attaching solenoids on the valve open and close according to the desired temperature, or amount of water needed.

$4.38

Pump Retainer

Sold Individually.

$3.02

Lid Hinge Mounting Screw

Sold individually.

$16.15

Tub-to-Pump Hose Kit

This kit comes with the clamps.

$4.89

D-Shaped Knob Insert

This insert is sold individually. Knob not included. Knob is sold separately.

$12.84

Break Hose

This hose goes from valve to inlet.

$12.10

Drive Block - 2 5/16" High

This part is for large capacity belt drive and direct drive appliances.

$6.36

Touch-Up Paint - White

This touch-up paint can be used on a wide variety of household appliances. It is most often used on washers, dryer, refrigerators, dishwashers, ranges, freezers, trash compactors, ...

$9.56

INLET HOSE

This hose can handle hot or cold water and is five feet long.

$4.37

Retainer, Suspension Spring

$5.51

Hose Clamp

The hose clamp is used to hold the water hose in place which will prevent the hose from leaking water. Sometimes the clamp may lose its ability to latch on, causing a leaking washer. For the installation, you will need a flat head screw driver to replace the clamp and a drill to access the screws to remove the front of the washer. Be careful if you do not have specific clamp pliers as the clamp could fly off. Once the front of the washer has been removed, take a quick look for water damage or any obvious signs of where the leak is coming from. If it is not obvious, run water to test.

$5.73

Washer

This part goes on the agitator retaining bolt.

$8.00

Bleach Dispenser - White

This part holds the bleach until it is ready to be released into the cycle.

All Parts for the 11016852503
15-28 of 184