Quick Question!

Have you ever purchased from PartSelect.com before?

Models > 11016612691 > Parts

11016612691 Kenmore Washer - Parts

All parts for the Kenmore Washer 11016612691

Below is a list of all parts for the Kenmore Washer 11016612691. To find the repair part you need, you can browse the list below or you can narrow your choices by searching for a part by name or description.

All Parts for the 11016612691
15-28 of 170
Search for parts
Keep searches simple, eg. "belt" or "pump". Need help?
$4.36

GASKET

This part may also be referred to as a main outer tub seal. This part prevents leaking from the bottom of the tub. The gasket is approximately 2 inches in diameter to the outer edg...

$2.90

Foot, Front - Single

The front facing foot is sold individually. It is used on your washing machine and can also be known as an adjustable leveling leg. This specific front facing leveling leg has a rubber foot. It is important that when installing this part you are very careful, if not installed correctly your washer will be off balance which will then cause it to vibrate and/or shake during the cycle. The function of the adjustable foot is to keep your washing machine supported and to make sure that it is level at all times. The tools you will need for this repair include a pair of channel lock pliers, and a 9/16 wrench.

$19.16

Drain Hose

It connects from the pump to the back panel.

$3.02

Cover Screw

Sold individually.

$3.02

Hose Clamp

This hose clamp is used in a wide variety of household appliances. Most often it is found in washers, dishwashers, refrigerators, freezers, dehumidifiers, garbage disposals, or air...

$4.40

Pump Retainer

Sold Individually.

$3.02

Lid Hinge Mounting Screw

Sold individually.

$16.19

Tub-to-Pump Hose Kit

This kit comes with the clamps.

$9.64

INLET HOSE

This hose can handle hot or cold water and is five feet long.

$5.73

Washer

This part goes on the agitator retaining bolt.

$4.37

Retainer, Suspension Spring

$5.51

Hose Clamp

The hose clamp is used to hold the water hose in place which will prevent the hose from leaking water. Sometimes the clamp may lose its ability to latch on, causing a leaking washer. For the installation, you will need a flat head screw driver to replace the clamp and a drill to access the screws to remove the front of the washer. Be careful if you do not have specific clamp pliers as the clamp could fly off. Once the front of the washer has been removed, take a quick look for water damage or any obvious signs of where the leak is coming from. If it is not obvious, run water to test.

$9.49

Water Inlet Hose

$203.86

Gearcase

This is used in your direct drive washer that has a neutral drain.

All Parts for the 11016612691
15-28 of 170