10659562990 Kenmore Refrigerator - Instructions

1. opened box with new drawer inside.2. washed new drawer. 3. opened fridge door 4. removed old defective drawer and threw it away. 5. Inserted new drawer 6. closed fridge door 7. opened fridge door to put veggies in new drawer. 8. closed fridge door when finished.

determend o.k. water flow,determend solenoids o.k.problem had to be ice maker.ordered part on Su. eve.,recieved new part Tue.A.M.,had part installed in 15 minutes. Then waited for quite a long time untill it finally made ice.

installed ice maker control & motor assembly

Very simple. Using only a screw driver removed all the screws and removed the front part of the ice bin. Then I removed the screw auger that pushes the ice out and reassembled every thing to the new ice bin.

The refrigerator door was not staying closed. Arriving home we found it open and not running. The compressor was off on thermal overload. In checking that and while cleaning the condenser I noticed the refrigerator door was 1/4" lower than the freezer. I saw how the door cams worked to keep the doors closed. The installation was easy. I blocked up the door. Removed the old cams using a small socket and installed the new. Door cams tool less than fifteen minutes.

Removal of escutcheon was easy. Replacing icedoor was fairly easy, working with wires in the way was a little distracting but simple. Be careful with microswitches and locating pins. Two of mine broke, had to replace bracket. Simple job again. Everything working fine now. No ice jam in chute. Using needlenose pliers to remove/insert pin is the best and easiest option.

Per directions supplied

The repair was extremely simple. The video was very helpful.

Figured out You have to pop off the cocer than remove the 1/4 hex head screws only not the philips ones

Removed the old one. The new one had a power chord attached but it did not connect to the wire in the freezer. I saw it could be unplugged from the new ice maker and the power chord from the freezer plugged right in. Once installed, was not sure it worked but after a few hours it filled with water and started making ice. Works great now.

I followed the instructions shown in the on-line video for replacing the thermostate control. I had difficulty freeing the capilary tube from around the mechanical lever that controls the freezer side vent opening. I had to remove a screw that held the vent lever in place. This is a delicate activity. I was not happy with the way the on-line video delt with this particular issue. Otherwise, the video was right on and straight forward. The problem is fixed.

Removed correct part from those provided and slipped it into position. No tools necessary.

Lower door closing cam was completely worn down so door wouldn't close on it's own. Ordered parts which arrived in a couple of days. After watching installation video on this website the job looked pretty easy. Needed socket wrench to loosen nuts at top, they were really tight. Removed door. Replaced both the cam on the bottom of door and the cam on the main unit, put door back on making sure it was straight and lined up properly. Retightened top nuts securely. Voila, problem fixed in only about 15 minutes or so.

I followed the instructions on the repair video, fridge is working fine now. Thanks!

I just wanted to tell about the good service they gave to me. The first one I received was broken, and with one phone call they sent me another, no problem. Installation was take the broken one out and replace it with the new one.