10650584000 Kenmore Refrigerator - Instructions

Replaces transmitter circuit board. Removed (3) screws and replaced board and replaced back into service. very easy!

Video made troubleshooting problem easy. I ordered the parts and 5 days later I had them. 10 minutes later they were installed and that night I had ice. This is the third appliance I have repaired using the partsselect video and replacement parts. All worked well. Much cheaper than getting a technician. Thank you. Cheap Guy!

Looked at drawing to see what sequence the parts went.

Trouble shot the ice maker using the read out codes. Code indicated a faulty ice maker. Ordered a new Ice maker and replaced the faulty ice maker. Only problem is the water funnel one the new ice maker is taller. This required bending the water fill tube to slide the new unit in place.

Opened package, opened fridge door snapped new shelf into place, no problem, took less than 1-2 minutes tops.

Easy fix. Used this a teaching opportunity for my 18 yr old son and had him do all the work. The cams have like little inclines that as the meet close the door with like a over center effect. Empty the door. Just undo the top plate 5/16 screws and lift door off. On bottom of door change the 1 piece lower door closing cam and on the bottom post plate change the door cam. add a little grease and reverse the process to install. later in life my son will know how to make this repair.....easy to do folks.

If you follow the video to the letter it's a piece of cake

Unscrewed water inlet support bracket,placed new inlet valve next to old valve with same orientation.one by one disconnected water lines and power leads and reconnected to same position on new valve.Reattached bracket and job done..Access to valve very easy.

Replaced the emitter and receiver boards by following the video instruction. Unscrew the cover plate, disconnect the wire, remove and replace the board and re-install. Repair was very easy and the unit is back in service.

1. Remove 3 phillips head screws with #2 phillips screwdriver. 2. Gently pull mounting bracket outward from freezer case. 3. Using fine needle nose pliers remove clip washer from lower end of flipper mounting rod. 4. Note position of flipper spring and pull mounting rod upward far enough to insert downward through new flipper and spring. 5. Install clip washer removed in step 2. Position assembly onto freezer cabinet and secure with screws removed in step 1.

remove old ice maker no fasteners and one electrical plugin and transfer plate from old ice maker and reinstall very simple. was delighted to see it arrive so soon........thanks for that

Used the instructions provided on the web site. They were very clear and easy to follow. I might add, I am an 82 year old 30 year military retiree and I am used to problem solving. Yours in service, Jimbo

The fix was easy. I jacked up the unit and put on blocks. I used socket and ratchet removed the wheels. Reinstall new ones and let off the blocks.

took screwdriver, took out old parts. replaced with new parts. plugged fridge back in, turned on receiver. We have ice! Real Easy to install! Thank you Part Select.

The hardest part was figuring out how to get the front panel escutcheon panel off. With the putty knife under the bottom flange, you need to push down with some effort on the part of the flange where the drip pan slides in and twist the putty knife to disengage the locking tab. Once the panel is off, the rest of the job is easy with the aid of your video. Everything works like new...thanks.