10650273010 Kenmore Refrigerator - Instructions

Followed the Partselect instructions - removed door, removed old cam and replaced with new cam. One lesson learned. There are two cams - one that sits on hinge below door and one that is up inside bottom of door. If you are replacing one, replace them both.

Opened freezer section of refergerator and taped Ice Maker cover door in the open position to remove emitter and receiver boards. Unscrewed the phillips head screws that secure the emitter board housing to the refrigerator side wall. Turned off power to the refrigerator and unpluged the emitter, removed the 2 screws that hold the emitter board against the housing and removed it, then I installed the new emitter board in the housing by screwing it in place. Repeated same process for removal and replacement of the receiver board. The whole process took me about 10 minuets.

Toughtoget the ta b into the paddle but once in it was ok.

Great

I removed the door and switched out the cams on the bottom. Super easy. Door closes perfectly now.

i talked to a gentlman name Ruben and directed me to the parts i needed i ordered them and put them by myself i ended up saving over 200.00 dollars thanks to Select parts the minute i finished the process and closed the freezer doors i could hear the ice is comin down again it was good feeling. After i changed the emitter and the receiver this year every thing is working again

Wash, dry, insert.

No prior experience in appliance repair. The majority of time was used in researching the problem and how to fix it. The Parts-Select website and the comments of prior customers made it easy to diagnose and repair. Unplugged the unit, popped of the ice maker cover to get it out of the way, unscrewed the plate covers for the emitter and receiver, changed them out, replaced the covers, replaced ice maker cover, plugged in. Moved on to the next problem.

watched video and did same thing,works great now,ordered parts friday morning arived saturday,very pleased!

The Crisper Pan ordered through PartSelect was a perfect replacement. The item ordered arrived quicker than expected. I'm very pleased with your service.

I did the repair, but apparently there's an Ice Door Kit with Bracket ( Part #8201756 - PartSelect Number PS990120 ) that has a metal bracket that will actually fix the problem with the broken plastic that holds the pin in.

Replaced the "Run Capacitor. The non-rythmic clicking associated with the compressor coming on continues. The problem was obviously not the Run Capacitor". I don't know what to do next. Any suggestion would be appreciated.

Thanks,

Phillip

The retaining pins, which are part of the control bracket, that hold the micro switch that powers on the ice dispensor had broken, allowing the micro switch to fall away from actuator paddle. I replace the entire control bracket which holds the 2 micro switches, one for ice dispensing and one for water.

I removed the outside ice door panel with two flat head screw drivers inserted in the slots at the bottom of the panel. You simply pry out until the bottom releases and then you push it up gently to release the top. I then removed the hex head screws that held the outside wire panel and the switches, at this time you need to remove the old plunger that is connected to the top of the ice door assembly. I then disconnected the old heat strip and removed the hex screw that held the ice chute at the bottom. Then I removed the pin and spring that held the ice door assembly at the top. Replaced the parts with new ones provided in the kit. The ice door is no longer freezing up, nor is the ice bucket in the freezer. The freezer is now back to the right temperature, without having to be set on high

Took the part out of the package and installed it. The service I received was excelent. Got the part two days after ordering it