Models > 10646039801

10646039801 Kenmore Refrigerator - Overview

Get Parts and Repair Help for 10646039801

If you know the refrigerator repair part you need, you can browse the list of all parts on the 10646039801, or you can search by name or part description. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your refrigerator. We’ve also included any installation videos we have for 10646039801 parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Search for parts
Keep searches simple, eg. "belt" or "pump". Need help?
$2.58

Light Bulb - 40W

Sold individually.

Order within the next 7 hrs and your part ships today!
$22.61

Dispenser Grille

This grille is located on the bottom of the ice/water dispenser to catch the overflow.

Order within the next 7 hrs and your part ships today!
$50.65

Ice Door Kit

This kit includes the ice door, support, spring and delay. The heater ribbon is no longer attached - the heater is no longer needed.

Order within the next 7 hrs and your part ships today!
$24.19

Bi-Metal Defrost Thermostat

If ice is building up in your freezer or if your freezer is getting too warm on the defrost cycle you may need to replace the bi-metal thermostat.

Order within the next 7 hrs and your part ships today!
$13.53

Micro Switch

This switch is located inside the dispenser.

Order within the next 7 hrs and your part ships today!
$4.66

Screw

This screw is sold individually.

Order within the next 7 hrs and your part ships today!
$65.14

Shelf Frame with Glass

This part is also known as Cover.

Order within the next 7 hrs and your part ships today!
$8.59

Light Rocker Switch

This light switch is triggered by the door opening and closing.

Order within the next 7 hrs and your part ships today!
$4.34

End Cap Trim Piece

Sold individually.

Order within the next 7 hrs and your part ships today!
$4.14

Light Bulb - 40W 120V

Sold individually.

Order within the next 7 hrs and your part ships today!
Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

Ice Maker would not stop making ice.

  • Customer: Vince from El Cajon CA
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Screw drivers
  • 139 of 152 people found this instruction helpful
First, I tested the ice maker "switch" that actually just covers the beam that regulates the ice maker. In the "off" position, it still made ice. Then, I removed the three screws on the cover over the transmitter and disconnected the circuit board at the wire connector. It stopped. After ordering and receiving the new transmitter and receiver boards, I repla... read more

Fridge was getting too warm, ice buildup on coils.

  • Customer: Cathy from Winter Park FL
  • Difficulty: A Bit Difficult
  • Time to Complete: 15 - 30 mins
  • Tools Required: Nutdriver
  • 88 of 97 people found this instruction helpful
WARNING: REPLACING THIS PART REQUIRES CUTTING AND SPLICING ELECTRICAL WIRES. RISK OF ELECTRICAL SHOCK OR FIRE. DO NOT ATTEMPT THIS REPAIR IF YOU ARE NOT EXPERIENCED WITH ELECTRICAL WIRING.

Part Info:
The bi-metal strip is clipped onto the evaporator coils and is designed to regulate the defrost coil temperature. If it is not functioning prope... read more

Warm Air Getting Into Freezer

  • Customer: David from Chesterfield MO
  • Difficulty: A Bit Difficult
  • Time to Complete: 30 - 60 mins
  • Tools Required: Pliers, Screw drivers, Socket set
  • 86 of 105 people found this instruction helpful
Patience is a virtue. The kit really works. 1st, lift the front plate of the ice dispencer by placing a flat head screw driver into the two slots at the bottom of the panel. When the panel is lifted up slightly at the bottom, push up on the panel to remove it. Careful not to break panel and the wires attached. Next, remove the wiring panel by removing the... read more