10645432801 Kenmore Refrigerator - Instructions

Got on your website and found our refrigs expanded layout and ordered the part. The removal and install was less than one minute Including the clean up.

I ordered both the Ice maker and the control boards as It was for a rental and I did not want to make more trips then necessary to repair. I installed the new control boards and the ice maker and the refrigerator now makes ice.

Followed the lead of david from chesterfield in prying off out cover, unplugging it and setting it aside. Unscrewed and pulled out next assemply, and taped it above work area to avoid having to unplug. The pried pulled out pin to right holding ice door hinge to remove old unit. (Notice which way the spring faces before removing!) unplugged it. Ended up taking off push-dispenser handle (one screw on right) to get easier access. Then reinserted long pin being careful to have spring with two long tongs pointing down. Then put everything back together. Use all parts!

The repair (really replacement) took less than 2 minutes. You press a button to pop out the old filter and stick the new one in. Easy as pie.

Had to Test Seloind. It Was OK. Then tested Motor Motor For Ice Maker. It Was Bad. Went Online Looked Up Parts For My Unit. They Were Shipped in a Timely Manner, only a few days. Installed parts in less than 15 minutes. Went very easy. Thank You

I simply followed the step by step instructions demonstrated in the online videos for replacing the electronic control boards - emitter and receiver. Just that simple. 15 minutes later the repairs were completed. We've had ice ever since.

I checked the trouble shooting guide with the refrigerator and all signs pointed to the Electronic control boards that sense when the ice tray is full. After reading what other customer posted on this site I ordered the parts. I received the parts in two days time and had a harvest of ice within minutes of installing it. Thanks PartSelect. Scott

repair was not to bad. removed 3 screws, then unplug wire harness. The next thing i did was removed clip that holds pin. slid pin back enough to put new flipper in place. needs to go in front of spring.once in place slid pin back in and put clip holder back on. Then plug wire harness back in and 3 srews . done.

With the flat screwdrivers, table knife or something to pull the front cover, is not easy but it will come out, patient and kepp trying until you made it, the rest is easy.

Replaced old drawer with new. Did have to remove white handle, the new one doesn't come with one. It was simply a matter of prying up the edge until it would come off and snapping it in place on the new one. Used the screw driver to lift pry up the edge.

The part arrived and we replaced both of the electronic control boards. Seemed fairly simple and immediately fixed the problem.

Watched video of repair. Took all drawers and drawer holders out of freezer to acesss back panel. Removed 6 screws from back panel,slid up and out. Cut 2 wires to remove old bi-mtl defroster. splice the wires and attached new bi-metal def.

Your directions were clear. When I took the control off the left side of the freezer compartment the resister burnt the plastic so badly that I had to pry cover loose. This may be a problem for others. Thanks from this "Do-it-yourselfer".

Removed and installed new control boards

Told Wife To Watch The Instructional Movie, Got Me A Beer And Watched Football. She Finished In about Thirty Minutes.Good Job