10644033601 Kenmore Refrigerator - Instructions

The replacement was easy, especially after watching the install video. Saved over $200 by purchasing the part at PartSelect and doing the install myself. Will use PartSelect again in the future.

I did not have voltmeter to test for problem. Internet sites suggested the most common problem is the circuit boards--a sender and a receiver which detect when the ice bucket is full. I could only buy as a pair (about $94). I removed two screws of cover of receiving unit, detached the coupler, replaced the circuit board. Icemaker now works. The sender was obviously still good.

Ordered part over the phone and received it two days later.....excellent service

Had repair people in a year ago and could not find problem-They changed water flow meter valve-(costly for parts and labor) Did not solve problem!I needed ice so purchased external ice maker used for 1 year-Told myself I know it is the ice maker-Got on line and ordered from PART SELECT! Only took a few days for part to arrive-I had watched video for changing parts out on line-Took only 10 minutes to duplicate video-In 45 minutes I had first ice in over 12 months-Has been working perfect since installation!Don Smith

Took The icemaker apart saw what parts needed to be replaced ordered them online put it back together Found the person I dealt with on the phone to be very knowledgeable very happy with the company Now the ice is flowing

Followed the instructions in the PartSelect video. It was so easy. Replaced the old ice maker on Monday. Visited a friend on Tuesday. Her Kenmore Frig's ice maker was broken, would not make ice. I told her how easy it was to fix and ordered the part for her today. It should be here by Tuesday and I will install it as soon as it comes in.

removed ice maker took motor assembly off the end of ice maker, and installed the new part. this was pretty easy because I have taken it apart before. But this is not a hard job for a novice.

Very easy - simply turn on the new cap.

The replacement ice maker water inlet was taller than the original. I had to disassemble both the new and old unit to replace the new water inlet with the old one. The video was very helpful in troubleshooting, removing and installing the unit.

Watcheda U-Tube type video of how to repair the unit. This was very helpful in that it identified a screw that had to be removed but was not visible upon my initial observations. Also it mentioned that you had to re-use some of the original hardware in order to complete the replacement. My only complaint is that I believe the failed motor could have been replaced for about $15 but I was not able to find that specific part in any catalog and opted to replace the entire unit. Overall I am extremely well pleased. Everything now works fine.

Followed the video. only problem old ice maker was frozen in place. Had to thaw out in order to slide old ice maker out of slot. other then that, new one is working fine.

research of company website showed parts to buy (per percentage of failure) and how to install those parts I viewed video on installation of parts and did the job, it was a snap

Web site is fantastic, I used web site to figure out my problem and order parts, I also used web site on how to install which made it a snap to do repair Ice maker up and running, all replacements parts were factory which fit perfectly

easy,remove old parts installed new parts,icemaker started working properly.

Followed instructions posted on your site. It was straight forward and very simple to complete.