10644029601 Kenmore Refrigerator - Instructions

The replacement went very easy, however I still have no ice. I'm not sure what to check for next. Any ideas? I unplugged it for about 2 minutes and nothing. I do not hear the water filling the unit, the water on the door works fine though.

Removal of escutcheon was easy. Replacing icedoor was fairly easy, working with wires in the way was a little distracting but simple. Be careful with microswitches and locating pins. Two of mine broke, had to replace bracket. Simple job again. Everything working fine now. No ice jam in chute. Using needlenose pliers to remove/insert pin is the best and easiest option.

I followed the video on your web site and that was it.

I fellow the installation instructions

I went exactly as the video claimed. I was almost too simple a repair.

Unplug A C Cord . Simply unscrewed lower back cardboard cover panel and unscrewed condenser fan motor , removed wiring plug , pulled fan motor out removed fan blade and put it on new motor . then I Reinstalled motor. Noise is gone . EASY INSTALLATION .

the water stain on the dispenser grille was unsightly even after cleaning with baking soda and vinegar, hence, we purchased a new one. popped the old one out and put new one in. have used parts select in the past and their pricing was very competitive if not better than over vendors.

Follow the video.

unsnap old teay snap new one in very easy

I just wanted to tell about the good service they gave to me. The first one I received was broken, and with one phone call they sent me another, no problem. Installation was take the broken one out and replace it with the new one.

Per the video, easy out & easy in.

Instructions were really clear and easy to follow. Hardest part of the job was moving the refrigerator away from wall after it was filled with holiday groceries.

Once we figured how to get front off, it was like a puzzle. One piece at a time. So thankful part has been improved and replaced. It works better than before, just wish would have done it sooner.

Remove back panel on unit locate condenser fan and motor remove three small screws holding motor assembly to metal bracket disconnect electrical connection press new fan blade on new motor reverse directions

remoove all the food and shelves out from the freezer section, remoove the light bulb lens ( 1 phillips screw) remoove light bulb, take out 6 srews on the back panel then slide out through the top with a slight bending curve motion, the bimetal thermostat will be clamped to the evaporator inlet, ( just after the cap tube) snap it off, then cut the wires about 2 inches from the stat, strip the ends about a quarter inch with wire strippers, same on the new stat, then use 16 or 18 gauge butt splices and crimp them , then reassemble in reverse order.