10641012101 Kenmore Refrigerator - Instructions

Remove inside door trim plate. Then removed three screws that held in the light assembly. The only difficult thing was reconnecting the temperature adjustment rod. After replacing this rod you must slide the temperature control slide to midway and this hold the rod in place while reinstalling the light assembly. If I were to do it again it would probably take me half as long.

Working from inside out . Remove left upper tube cover and then vent cover . Remove thermostat tube from around the vent . Remove knobs and front cover . Remove 4 hex screws , drop the whole unit enough to expose the left control rod , remove the rod retaining clip . Gently separate control rod from unit . Take the whole unit to working bench or table . Remove thermostat and bracket . Need to reuse bracket with new thermostat . Don't forget the clear plastic tube you have to reuse that as well . Be careful not to kink the thermostat tube . Reverse procedure , working from outside in . Good luck

Only the compressor fan was running with no cold air, the compressor wouldn't kick on. I pulled the start relay and the disc inside was in pieces ( rattled when you shook it). I ordered the new one and installed it. The compressor started running right away and cold air was delivered to the freezer.

Followed instructions on this website. Only difference I placed a couple blocks under the door to keep it from dropping & removed both cams at the same time. No need to remove the door from the unit.

'Not complicated. I ordered the part and put it in the door. I love you guys. I have bought refrigerator and oven parts over the years and the service has been great, but the best part is the website with photos and repair info. Thanks much!

After watching the convenient movie, the replacment of the Thermostat was very simple and easy. i woul strongly advise you to take a picture of the wires before disconecting so, you will be sure to to reconetc it again.The replacment was a success and the refrigerator has been working since them

Removed the old cam and put books under the door to hold it up. Follows instructions and really easy

remoove all the food and shelves out from the freezer section, remoove the light bulb lens ( 1 phillips screw) remoove light bulb, take out 6 srews on the back panel then slide out through the top with a slight bending curve motion, the bimetal thermostat will be clamped to the evaporator inlet, ( just after the cap tube) snap it off, then cut the wires about 2 inches from the stat, strip the ends about a quarter inch with wire strippers, same on the new stat, then use 16 or 18 gauge butt splices and crimp them , then reassemble in reverse order.

ordered new replaced the old just slid in.

Turn off power. Remove freezer shelves. Remove six screws on the back of the freezer. Slide out metal piece. Pop off plastic fan piece. Remove motor mount by squeezing metal bracket. Take off wires... Do reverse... Attach wires to new motor, install motor (may have to also use the clear rubber piece from the old motor which keeps the motor in place). Push fan blade back on. Screw in metal plate, turn on power. Good videos on YouTube as well.

googled the model of ice maker and refrigerator, ordered replacement ice maker from Part Select. Received next day, installed it in 10 minutes and it worked like a charm.

We logged on looking for a possible cause and solution. We found your website, diagnosed the problem, ordered the part and it came in two days. You even had a step by step video on how to change out the part. Kudos to you. Thank You

New part was not needed, when I removed lower closing cam the lower part of the closing cam attachment screw had worked it's self lose. So it just needed to be re-torqued. That took care of the problem.

We suspected the thermostat assembly was the problem. We reviewed the video provided by PartSelect and accessed the thermostat assembly. To ensure the thermostat assembly was likely the culprit, we used a multimeter to test it. We ordered the assembly from PartSelect and were pleasantly surprised at the speedy delivery. Using the same video, we replaced the assembly and put the refrigerator back together. Thank you so much for saving us money we didn't have for the repairman. We will be ordering again soon to repair a leaky waterline and ice maker.

I was cleaning my refrigerator. When the glass shelf was being cleaned it barely bumped the bottom of the sink. There was no water in the sink. The shelf exploded into thousands of small pieces simular to a car windshield. I was devastated! I went online and ordered a replacement that same day. The next morning I was on my front porch watering plants when a delivery truck pulled into my driveway. It was the replacement shelf. I cannot believe the fast service. Thank you.