Models > 1034347225

1034347225 Kenmore Cooktop - Overview

Get Parts and Repair Help for 1034347225

If you know the cooktop repair part you need, you can browse the list of all parts on the 1034347225, or you can search by name or part description. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your cooktop. We’ve also included any installation videos we have for 1034347225 parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Search for parts
Keep searches simple, eg. "belt" or "pump". Need help?

Drip Bowl - 6"

This six inch chrome drip bowl is intended for use with rolled terminal style plug in surface element units.


Drip Bowl - 8"

Sold individually. This part is located beneath the element and catches any spills.


Surface Burner Terminal Block Kit

This kit comes with the terminal block, mounting clip and wires.



Sold Individually.










Common Symptoms of the 1034347225 [Viewing 1 of 1]

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

There was no heat on the coils.

  • Customer: Shaohui from East Lansing MI
  • Difficulty: Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Pliers
  • 31 of 34 people found this instruction helpful
I opened the lid, and found that the terminal blocks were burnt, the wires were melted. I ordered one set of terminal block to replace the burnt one, and it worked. Before I started, I shut off the electricity in the whole house to be safe. read more

Surface burner coil did not work.

  • Customer: Gregory from Mont Belvieu TX
  • Difficulty: Easy
  • Time to Complete: 30 - 60 mins
  • Tools Required: Nutdriver, Screw drivers, Socket set
  • 19 of 26 people found this instruction helpful
TURN OFF ALL POWER TO KITCHEN. Took off all burner coils and plates below them. Lift hood. Locate part. Remove old part and replace with new part in same way as was previously installed. The wire that comes with the kit is actually too much wire, but just arrange it the best you can and leave big deal. I didn't have a magnet, but needed one. T... read more

Burners would not lay flat

  • Customer: Alfred from Forest VA
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required:
  • 4 of 8 people found this instruction helpful
Removed the burner elements, removed and disposed of old drip pans, cleaned the area, relaced with new drip pans and replaced the burner elements. Verified all burners were level - good as the day it was new! read more