Microwave Ducts and Vents

Popular Microwave Ducts and Vents

Your Price
$15.73
  In Stock
Microwave DAMPER
PartSelect Number PS1018887
Manufacturer Part Number WB06X10686
Your Price
$105.80
  In Stock
Microwave VENT
PartSelect Number PS12071388
Manufacturer Part Number 5304509646
Your Price
$14.08
  In Stock
Microwave Damper
★★★★★
★★★★★
4 Reviews
PartSelect Number PS3524148
Manufacturer Part Number 4900W1A001B
This metal vent damper door closes off the exhaust duct when the fan is not running to stop outside air from entering the microwave unit, and opens when the fan turns on to allow air to vent away from the microwave. This vent damper door measures approximately 10 inches long x 3 inches wide and fits LG microwaves.
Installation Instructions
Rene from MORENO VALLEY, CA
Wanted to see the instructions before I install it.
Wanted to see the instructions before I install it. Read more...
Your Price
$21.24
  In Stock
Microwave Air Duct Bracket
★★★★★
★★★★★
2 Reviews
PartSelect Number PS3523851
Manufacturer Part Number 4810W1A151A
This bracket holds the metal or plastic flapper that closes off the exhaust duct when the fan is not running and opens when the fan turns on. If the exhaust fan on your microwave does not appear to be working, the problem may be with the damper assembly. If the damper does not open and close easily, check for any damage to the bracket, and replace if it is damaged or faulty. This genuine OEM exhaust damper measures approximately 12 inches long by 5 inches wide.
Your Price
$73.10
  In Stock
Microwave DAMPER
★★★★★
★★★★★
7 Reviews
PartSelect Number PS11728088
Manufacturer Part Number W10843943
This damper is an authentic OEM replacement assembly used in microwave/range hood combos. It includes the damper door and frame. It is designed to direct the flow of air through the vent duct, and the release of steam and heat from the appliance during cooking. Over time, the damper door and frame can wear down or become obstructed by food particles and debris. A faulty damper assembly will result in poor ventilation, uneven cooking, and excessive moisture buildup which can damage internal components in the appliance. Disconnect any wires or connectors attached to the faulty damper assembly and remove it from the appliance. Position the new damper assembly and reconnect the wires/connectors before securing it with the appropriate fasteners.
Fixes these symptoms
Your Price
$94.04
  In Stock
Microwave Bottom Vent - Stainless Steel
★★★★★
★★★★★
1 Review
PartSelect Number PS11753522
Manufacturer Part Number WPW10351279
Your Price
$47.69
  In Stock
Microwave DAMPER ASSEMBLY
PartSelect Number PS2203383
Manufacturer Part Number 5304464343
This is an exhaust damper assembly for a microwave, which is also known as a microwave vent damper. The damper directs air flow through the vent duct from the top or rear of your microwave, depending on your model, to allow the air to flow outside and prevent outside air from coming in. You will need to uninstall your microwave from the wall to access the exhaust damper. Once you have gained access to the damper, simply slide the old part out, and slide the replacement part in. This is an OEM replacement part that is sourced directly from the genuine manufacturer.
Installation Instructions
Mark from Morrisville, NC
Wanted to switch mv from recirc vent to venting outside
The mv was originally installed as recirc venting as there was no outside vent. I hated the steam and smoke just being put back into the kitchen.

I removed mv unit, ran a vent thru cabinets, thru attic, to outside vent. Installed new part on top on mv, installed mv and hooked up to new vent.

Works great now. Getting a good tight seal was difficult because the area the vent ran was so small.
Read more...
Your Price
$15.99
  In Stock
Microwave Damper
PartSelect Number PS952387
Manufacturer Part Number WB06X10565
This vent damper is a manufacturer-approved replacement part for your above-range microwave. This part helps vent air from the microwave to the exterior of your home, and helps keep exterior wind out of the vent. Replacing the vent damper will require some disassembly of your microwave/ Unplug the unit before beginning work on it.
Installation Instructions
Georgia from West Chester, OH
I needed a bracket to install my microwave
I wasn't sure which parts I needed.We searched several web sites until we found yours.I was real pleased with the service. My parts where delivered in a timely manner. Everything I needed to install my microwave was in my order. Thank you for the service.
Georgia westchester ohio
Read more...
Your Price
$63.90
  On Order
Microwave Adapter Assembly,vent tube ,w/converter
PartSelect Number PS1146692
Manufacturer Part Number 318317100
Your Price
$29.14
  In Stock
Microwave Vent Damper
PartSelect Number PS8767001
Manufacturer Part Number WB06X10935
The vent damper attaches to the outer cabinet and directs airflow through the vent duct.

Microwave Duct or Vent Brands