Have you ever purchased from PartSelect.com before?
Thank you for helping make our site better.
Enter your model number or a part number and click "Search"
Got a broken Kenmore cooktop? PartSelect.com can help. To find the Kenmore part you need, try searching with your cooktop model number. We offer same day shipping on all in-stock parts and free installation videos to help you complete your Kenmore cooktop repair.
drawer glides were broke on front and back
used a screwdriver pushed the old ones out put the new in. the video instructions were great....read more
old burners gone bad
tries brazing ends back onto posts...it did work but still not as good as I wanted. Bit the bullet for 100.00 and bought 2 new burners and drip pans. Only regret was not buying the two smaller burners...read more
Burners would not lay flat
Removed the burner elements, removed and disposed of old drip pans, cleaned the area, relaced with new drip pans and replaced the burner elements. Verified all burners were level - good as the day it...read more
No Ice or water through the door
Shut water off, removed back cardboard panel from fridge, disconnect water supply to valve, disconnect electrical plugs to water valve, removed defective valve, cut flexible copper supply tubing as co...read more
Back Burner didn't function
We moved into our townhouse about 6 yrs ago. During the home inspection we checked the range and saw the Red light come on when we turned on each burner. After moving in we realized the large back b...read more
The cooktop had a shorted out burner control.
Unpllug the cooktop and turn off the gas supply. Remove the grates and burners.(they just lift out). Using a torx screwdriver, remove all the torx screws below where the burners sit. There are three s...read more
Cord was not tightened enough by delivery crew.
PF alarm appeared on display. Noticed clicking when cord was moved. Had arced for some time and melted original block. New part slightly different. Only has 3 lugs, old one had six. Stack using washe...read more
Lower baking element would not heat up.
Your online instructions said to remove the two screws and pull out the heating element about 3 inches and disconnect. When I did this the element came out but not where it was connect to the wire., I...read more
Oven Igniter Died
The only difficult part of the repair was getting the original screws out of the old igniter and oven gas arm. Once I drilled the old screws out the repair was done within 20 minutes....read more
Below are the most popular Kenmore Cooktop models we have.
Enter your model number in the search box to find your model.
All brand logos are trademarks of their respective owners.
The PartSelect logo is a Registered Trademark of Atlantic Laundry Centres, Ltd.
Copyright © 1999-2017 , Eldis Group Partnership. All rights reserved.