Keys 6,7,8,9,0 were no longer working on the control panel

ApplianceJenn-Air Range

ModelJES9800

Level of DifficultyEasy

Time to do repair15 - 30 mins

Age of Appliance5 - 10 years

Tools Nutdriver
Screw drivers

Mark From Raleigh, NC

May 30, 2008

9 out of 11 people found this instruction helpful

** Recommend 2 people to do this job **

Turn the circuit breaker to the range off. Pulled the range out, removed the 4 stove knobs, unscrewed the 2 black screws for each stove control. Then removed four white screws from the ends of the control panel assembly. Opened the oven door and removed the four black screws that hold the bottom of the control panel assembly. Pulled the assembly out. From the inside of the assembly, I removed the ribbon cable from the circuit board (you'll notice there's one on the new assembly). Then, I unscrewed the four silver screws that hold the circuit board in place. Carefully removed the circuit board, the 4 stove controls, slid out the 4 stove lights and popped out the 4 red stove light covers. With a nutdriver, I removed the four silver nuts that hold the black metal piece to the assembly.
With the new assembly, started by putting the black metal piece in place (4 nuts) and inserted the red stove light covers, put the circuit board in place (sliding the ribbon cable from the new assembly near its port). Screwed in the 4 silver screws, then carefully attached the ribbon cable to the circuit board. Reattached the 4 stove controls (2 black screws for each) and slid in the 4 stove lights. Screwed in the 4 white screws at the ends of the control panel assembly and the four black screws for under the assembly. Turned the power back on. Good to go!

Help other customers find the most helpful instructions.

Were these instructions helpful?

Diagrams and Parts List for this repair

Part PhotoPart DescriptionPriceAvailability

USE WPL 74005748 (Now subbed to Control Panel With Touch Pad - White)

Part Number: PS2083475

$246.39
In Stock