Digital Display on oven went out

ApplianceJenn-Air Range


Level of DifficultyEasy

Time to do repair30 - 60 mins

Age of Appliance5 - 10 years

Tools Nutdriver
Screw drivers

Margaret From San Antonio, TX

May 05, 2008

0 out of 1 people found this instruction helpful

I followed other postings about this repair. It was easy. Open oven door, remove 4 screws that secure oven in the cabinet. Slide oven out a few inches. I thought it would be too heavy for me, but it wasn't. Remove 4 screws along the underside of where the clock panel sits. Have the oven door open, look up and you will see the four screws. Lift up and off for the glass front of the clock area. Undo the 4 sets of wire connections. They just snap in and out. Lay the glass on a towel, remove the clock assembly with a nut driver, replace with new clock assembly and reverse the instructions. When putting the glass panel back on, make sure you hook it over the top ledge. I missed that and after I replaced the 4 screws, I realized the top was not secure. Don't forget to kill the circuit breaker while working on this.

Help other customers find the most helpful instructions.

Were these instructions helpful?

Diagrams and Parts List for this repair

Part PhotoPart DescriptionPriceAvailability

Electronic Clock Assembly (Now subbed to Electronic Clock Control Board)

Part Number: PS2078472

Recycling Rebate Available
In Stock