Washer would not spin or drain

removed 2 screws panel to top. Slid panel out and disconnected about 3-4 connectors and a hose to the water level switch. Removed clips from the top to back . Undid connector that is pushed thru sheet metal top (this is the end of the pigtail of the part I replaced). pried harness from two clips securing to the underside of the top after leaning the "shell" forward. Disconnected the ground wire, and 2 screws holding switch to inside of lid. once installed reverse procedure.

****NOTE when putting back together: make sure the bottom of the cabinet lines up with the "channels" in the base, and the back lines up with the back of the case. If not there is no strength to move the washer around.