Water Inlet Valve leaking

ApplianceKitchenAid Dishwasher

Model

Level of DifficultyEasy

Time to do repair30 - 60 mins

Age of Appliance5 - 10 years

Tools Pliers
Screw drivers
Wrench set

Raymond From Richboro, PA

Jun 02, 2014

1-Turn off water supply.2 remove any fasteners holding dishwasher to countertop and slide dishwasher from under counter - 3-Remove black plastic retainer from lower left corner of left side of dishwasher. this retainer holds the white insulation sheet in place.4-remove upper and lower racks.5-lay dishwasher over on it's right side.The valve is plainly visible. 6-remove electrical connector. 7-Use pliers to release clamp and remove rubber hose.8-Remove brass fitting. 9-Use 1/4 nut driver or socket or screwdriver to remove two screws attaching black front panel which covers the opening near the floor when the dishwasher is upright.10-use Phillips screwdriver to remove 1 screw holding the water valve to frame. 11- Remove 90degree brass fitting from old valve.12-Attach fitting to new valve using Teflon tape on threads.13- after mounting valve with screw,follow steps 1 thru 9. Turn on water supply and check for leak before turning dishwasher upright. Run wash cycle to check operation.Slide back into place.

Help other customers find the most helpful instructions.

Were these instructions helpful?

Diagrams and Parts List for this repair

Part PhotoPart DescriptionPriceAvailability

Water Inlet Valve

Part Number: PS2348011

$40.20
In Stock