Leaking Water Pump

ApplianceRoper Washer


Level of DifficultyReally easy

Time to do repair15 - 30 mins

Age of ApplianceMore than 10 years

Tools Pliers
Screw drivers

Paul From Miton, DE

May 27, 2014

I disconnected the washer from the water hoses and unplugged it. I laid it down on its back and the pump was right there on the bottom front. There were no clips holding the pump. With a pair of Channel Locks I disconnected the two hoses from the pump. I had to pry it off using a screwdriver. The pump shaft was rusty from the water leak so I wire brushed off. I put the new clips I ordered in place and pushed the new pump on. I then snapped the back clip on first because it was easier with a little tilt of the pump. I had to use my screwdriver to put the outside clip on. I reconnected the hoses put the wash back upright hooked up the water hoses and plugged it back in. I turned on and no leaks and is working good.

Help other customers find the most helpful instructions.

Were these instructions helpful?

Diagrams and Parts List for this repair

Part PhotoPart DescriptionPriceAvailability

Direct Drive Water Pump

Part Number: PS342434

In Stock

Pump Retainer

Part Number: PS898394

In Stock