Water wasn't mixing--I'd get warm & hot, but never cold.

ApplianceMaytag Washer

ModelMAV7650AWW

Level of DifficultyEasy

Time to do repair30 - 60 mins

Age of ApplianceMore than 10 years

Tools Nutdriver
Pliers
Screw drivers

Deborah From Cana, VA

May 05, 2014

Narrowed it down to the valve or the analog control board. All comments seemed to favor the board, so I bit. Ordered it, got it in three days. To replace this board: Make sure power is unplugged to the washer. 1--Gain access to the rear or right side...this repair cannot be done from the front. 2--The control front has a removable back, held on by three (3) Phillips screws on the top and two (2) 1/4 inch nuts on the bottom. Remove all five and take off back of control panel. 3--This control board rests on four (4) plastic standoffs underneath the timer mechanism. Super easy to spot. Has a main wiring connector (multiple wires, I didn't count). Remove it. It has a safety bayonet latch, so work it off easily. Only goes in one way, so you cannot mess it up. 4--To remove the board, the standoffs are also bayonet-style. Press them together with pliers (I used my fingers) and they'll release the board. 5--Put new board on, in same orientation as old board (so that the wiring connector lines up correctly). 6--Plug in wiring connector. 7--Test before bolting everything back together. 8--Put back on. Honestly, an easy, easy repair. Mine worked like a charm. Didn't even know we had no cold water until our son came back from the Army and he was used to cold water; wife and I always used warm, but this fixed it PERFECTLY.

Help other customers find the most helpful instructions.

Were these instructions helpful?

Diagrams and Parts List for this repair

Part PhotoPart DescriptionPriceAvailability

Analog Water Temperature Control Board

Part Number: PS2021438

$122.12
In Stock