Dishwasher would fill properly but when wash cycle would start you could not hear any water spraying.

ApplianceMaytag Dishwasher

ModelMDB7600AWW

Level of DifficultyEasy

Time to do repair15 - 30 mins

Age of Appliance1 - 4 years

Tools Pliers
Screw drivers

Timothy From Trevor, WI

Mar 07, 2008

15 out of 16 people found this instruction helpful

First I removed the lower spray arm by removing the middle retainer nut. Next remove the 3 screws holding the outer shroud in place. Next remove 6 screws holding the water pump top housing in place. Under this housing you will find the impeller which is retained by a screw. Check the impeller closely for cracks especially near the center hex portion of the impeller. Replace if you have any doubt of it's integrity. Next remove the lower pump housing that has the screen material in the center. What I found was the nylon part that attaches to the shaft of the motor was stripped so the impeller would spin in it's normal direction ( counterclockwise) but under the load of water it would not. So I ordered a new impeller and seal kit with a metal sleeve and chooper blade. Follow the instructions provided in the new kit a reassemble accordingly.

Help other customers find the most helpful instructions.

Were these instructions helpful?

Diagrams and Parts List for this repair

Part PhotoPart DescriptionPriceAvailability

USE WPL 99002659 (Now subbed to Wash Impeller)

Part Number: PS2100007

$16.95
In Stock

USE WPL 6-919539 (Now subbed to Seal and Chopper Kit)

Part Number: PS2341057

$66.66
In Stock