Washer woulp not spin, brake cam driver not like video

ApplianceWhirlpool Washer

Model

Level of DifficultyA Bit Difficult

Time to do repair1- 2 hours

Age of Appliance5 - 10 years

Tools Pliers
Screw drivers
Socket set
Wrench set
Wrench(Adjustable)

Jody From Elk Creek, CA

Sep 21, 2013

changed parts easily, following the video. Problem was the BRAKE CAM DRIVER, the plastic piece that fits around the shaft near the drum. The old one was visibly torn up, the pegs worn off, the whole thing worn down. The problem with the repair was the video showed an "E ring" holding it on and my washer had no E ring, had nothing hold it. It just sat there. Installed it anyway, although I was worried it was too loose. Sure enough there was a problem. it spun initially then started that ugly clicking noise. turned off washer immediately, disassembled again, and prayed. I found a large flat washer to take up the slack between the clutch and the plastic brake cam driver, reassembled, tightening the nuts a fair bit tighter than before. both the nuts on the transmission and the nut on top the agitator. works perfect!

Help other customers find the most helpful instructions.

Were these instructions helpful?

Diagrams and Parts List for this repair

Part PhotoPart DescriptionPriceAvailability

Clutch Assembly

Part Number: PS334641

$28.77
In Stock

Direct Drive Motor Coupling

Part Number: PS1485646

$11.77
In Stock